World Market 527211 User manual

SHELF BRACKETS BLACK ARCHED FINISH
SKU - 527211
THANK YOU FOR YOUR PURCHASE. IF YOU HAVE ANY QUESTION PERTAINING
TOASSEMBLY OF THIS PRODUCT, PLEASE CONTACT THE
NEAREST COST PLUS WORLD MARKET STORE. IF YOU ARE NOT NEAR ASTORE,
PLEASE CALL OUR CUSTOMER SERVICE CALL CENTER
TOLL FREE AT 877-967-5362 FOR ASSISTACE.

Parts List
Picture Description QtyLabel
A
Page 2
Tool List
Hardware List
H-1
H-2
T-2
T-1
T-3
2
4
4
1
Screws
(L32mm x 4mm)
Wall Plugs
(L42mm x 10mm)
Bracket
(Drill Bit -10mm)
Allen Key
Screw Driver
4H-3 Allen Bolt
(L17mm x 6mm)

Turn the ledge in upright position. Locate the stud on the wall. With the help of two people, align assembled ledge on the
wall and mark the location of the hole. Use water leveler to ensure that ledge is in level. Pre-drill holes at marked
location.
Place ledge on a non-marring padded surface. Align bracket (A) end with oval holes over ledge as shown above
in the image. Insert allen bolt (H-3) in the holes and secure with allen key (T-1). Repeat the process to secure
other bracket.
Step-1
Assembly Steps
Page 3
A
H-3
H-3
H-3
T-1
H-3 A
Leveler
A
A
A
T-2
Wall
T2
not included

Assembly Steps
Step-2
Assembled view
Page 4
Wall
T-3 H-1
Wall
anchor
Wall
anchor
Wall
anchor
Wall
anchor
A
A
H-2
H-2
T-3
H-2 A
A
H-2
Insert wall plug (H-1) if you are mounting on a dry wall. Insert screw (H-2) into wall plug (H-1) as shown above in the
drawing. Leave 1/4"of the screw (H-2) out of the wall as shown above in drawing. Align keyhole over screw (H-2) and
pull down ledge until secured. Insert screws (H-2) at lower ends and fully tighten connections with screw driver (T-3).
Note - Bracket set is meant to be used with World Market shelves sold separately.
Maximum Load - 50 lbs
Wall
T-3
H-2
Screw
H-2
Screw