Web Direct Above Ground Pool Safety Fence Gate User manual

Above Ground Pool
Safety Fence Gate
Installation Guide
Installation GuideInstallation Guide
Installation Guide
WARNING
This fence is not a substitute for adult supervision! Do not leave children in
or around your pool without constant adult supervision!
• A fence is just one layer of defense for your pool. We highly recommend that in
addition to the adult supervision you have multiple layers of pool defense.
• The pool entrance should remain locked using a self-closing and self-latching
gate. That gate should be checked and maintained regularly.
• Building codes are different for all areas; please check ith your local code en-
forcement department before purchase or installation for requirements in your
area.
• This above ground pool fence is not designed as a handrail for decking and does
not meet handrail codes.
• The gate is not self closing self latching. The gate is only of convenient entry
not for prevention of access to the pool. Alternate safety products should be
used in with the gate. This may include but is not limited to: folding safety
steps, self closing hinges, self latching lock.
Web Direct Brands, Inc - Support 9am - 9pm ET - 1-877-349-3362

Pre-Installation
• Read the directions completely before beginning.
• Inspect the pool for impediments to installation. Check to make sure that braces are clear of
obstacles and intact.
• Find the skimmer and make sure that it ill not interfere ith the planed location of the pool
fence.
• Gather the tools needed for installation: cordless drill ith Phillips head scre driver bit, sa ,
pencil and measuring tape.
Part verview Above
Step 1
The gate is held to the upright by the base; assemble the mounting base ith the support. Secure
them together using t o scre s in both sides of the base / support joint. The support should be
positioned prior to scre ing in flush ith the backside of the base for full support.
Web Direct Brands, Inc - Support 9am - 9pm ET - 1-877-349-3362

The maximum idth of the gate is 38". If you do not have t o uprights positioned ithin that
measurement, use an artificial upright for one of the gate posts.
Web Direct Brands, Inc - Support 9am - 9pm ET - 1-877-349-3362

Web Direct Brands, Inc - Support 9am - 9pm ET - 1-877-349-3362
Step 2
Install mounting brackets created in the previous step. The posts for the gate take the place of
the end posts for the fence. The fence ill connect to the gate posts the same as in the instruc-
tions for the pool fence installation. Slide the gate posts into place allo ing 1/2 inches bet een
the inside face of the post and the pool all top. Use the provided scre to secure the posts in
place.
Step 3
Build the gate next by measuring the gap bet een the inside faces of the t o gate posts. Sub-
tract 1/2" from that measurement and cut the top and bottom rail. When cutting be sure to cut
even amounts off each end for even spindle spacing. Assemble the top and bottom rails ith the
spindle and then insert into the vertical gate ends. Before securing ith scre s double check the
gate fits bet een the t o gate posts and that the gate is square.

Step 4
Install the hinges and latch to hold the gate in place. The gate should s ing a ay from the pool.
Install the hinges first on the left of right hand side. Verify that the gate is flush ith the top of
the fence and is level. Lastly attach the latch.
The gate is not self closing self latching. The gate is only of convenient entry
not for prevention of access to the pool. Alternate safety products should be
used in with the gate. This may include but is not limited to: folding safety
steps, self closing hinges, self latching lock.
Web Direct Brands, Inc - Support 9am - 9pm ET - 1-877-349-3362
Step 5
Finish the gate by adding caps.