Weber Summit 475 User manual

SUMMIT™475 & 675
Built-in Sleeve
97070 12/96
Serial Number
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
WARNING: Follow all leak check procedures
carefully in this manual prior to barbecue
operation. Do this even if barbecue was
dealer assembled.
WARNING: Do not try to light this appliance
without reading "Lighting" instructions section
of this manual.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, immediately call your
gas supplier or your fire department.
FOR YOUR SAFETY: Do not store or use
gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.

REMOVE PACKAGED
PARTS
Back panel
Rail (2)
Right panel
Left panel
Bottom panel
ASSEMBLE BACK PANEL
TO BOTTOM PANEL
ASSEMBLE LEFT PANEL
TO BOTTOM PANEL
8-7/8 screw (22)
Front door
Place the back panel perpendicular to the bottom panel.
Insert screws and tighten. Figure 1.
Place the left panel perpendicular to the bottom panel.
Insert screws and tighten. Figure 2.
Figure 1
Figure 2
Nylon washer (4)
Bushing (2)
Spacer (2)

ASSEMBLE RAILS TO
LEFT PANEL
ASSEMBLE RIGHT PANEL
TO BOTTOM PANEL
ASSEMBLE BACK PANEL
TO SIDE PANELS
Insert the rails into the left panel. Figure 3.
Place the right panel perpendicular to the bottom panel.
Guide the rails into the right panel. Insert screws and
tighten. Figure 4.
Insert screws along the side of the back panel. Tighten.
Figure 5.
View from back
Figure 3
Figure 4
Figure 5

ASSEMBLE DOOR TO
SIDE PANELS
Add two washers on each end of the wire. Insert the
bottom wire of the door into the bushing of the left panel.
Pull the wire up and in to insert it into the bushing in the
right panel. Figure 6.
Once the bottom wire is in place, push it down so it snaps
into the bottom flange to lock it in place. Figure 8. Close
the door. Turn the knob clockwise to close. Figure 9.
View from front
View from top
Close Open
Figure 6
Figure 8
Figure 9
ADD SPACERS AND
BUSHINGS
Push in the bushings into the bottom holes of the side
panels. Insert screw through the spacer and into the
second hole in the middle of the side panels at the cutout.
Tighten. Figure 6.
Spacers
Screws
Bushings
View from front
Washers
Figure 7
Spacer
Spacer