WEBTEC C2000 User manual

Starting up the System
Windows Setup Information
1. Make sure the power to the UPS is on then press and hold the front button of
the UPS until it powers up.
2. Turn on the power to the C2000 data acquisition unit. The switch will glow red
when on.
3. Turn on the power to the industrial computer.
4. The industrial computer will boot up in Windows and the C2000 software will
run automatically.
•The industrial computer is pre-installed with Windows 7, Acronis software, the
C2000 software and the UPS management software.
IMPORTANT: Use the Acronis software to make a complete backup of your
system and store it on an external hard drive, memory stick or network location.
IMPORTANT: Do not install additional software or connect additional auxiliary
devices on this industrial computer without consulting Webtec, it can aect
the system’s performance and readings.
• The industrial computer can be connected to your corporate network using the
second (Arrow F) network port. By default this is setup to use DHCP.
IMPORTANT: Do not adjust any of the settings on the network port connected
to the C2000 data acquisition unit.
C2000
Getting Started
Designed and produced by Webtec Graphics. GETSTRTD-IN-ENG-2385.pdf 11/14 FT10289 Version 9
Webtec Products Limited reserve the right to make improvements and changes to the specication without notice.
www.webtec.com
www.webtec.com

Contents
1. Unpack and locate the industrial computer, C2000 data acquisition unit and
UPS into a 19” rack (when rack not supplied).
2. Connect the keyboard and mouse to the industrial computer USB ports.
3. Connect a Monitor (not supplied) to the rst DVI port (Arrow H1) on the industrial
computer.
4. Connect the network cable from the C2000 data acquisition unit to the left
hand network socket (Arrow E) on the industrial computer
5. Connect the UPS power leads (male/female) from the UPS (Arrows B & C), one
to the industrial computer, one to the C2000 data acquisition unit.
6. Connect the RS232 data cable between the industrial computer (Arrow G) and
UPS (Arrow D).
7. Connect the mains power input to the UPS (Arrow A) using the mains lead
(from box 2).
Setting up the C2000 System Hardware
1. Connect the sensors to the C2000 data acquisition unit.
a. If you have purchased sensors with the C2000 then connect them as per
the supplied Sensor setup guide and the software has been pre-congured.
b. If you have purchased the sensors separately or already have sensors then
they can be connected in any appropriate channel. The 8 input modules
accept 4-20mA signals (see also 4-20mA input module setup guide) and the
6 input modules accept TTL signals. To setup the software appropriately
for each channel see the online help.
Connecting and Setting up the Sensors
Box 1 C2000 Hardware Interface
qC2000 Rack mountable data acquisition interface unit
Box 2 Industrial Computer
q Industrial rack mountable computer
qKeyboard & Mouse
qRecovery/Drivers CDs (already pre-installed by Webtec on industrial
computer)
q Hardware guide & test certicate
qNetwork cable
qMains Lead (except 110v systems)
qC2000 Software CD (already pre-installed by Webtec on industrial
computer)
qC2000 Getting Started (this document!)
q C2000 Channel Conguration document
Box 3 Uninterruptable Power Supply
qRack mountable UPS
qUPS getting started guide & manual
qUPS driver CD (already pre-installed by Webtec on industrial computer)
q2 x Power leads
qRS232 lead
qRack mounting kit
Assembled System
q19” Rack (optional)