Weego 22S User manual

Model No. 22s
OWNER’S
MANUAL
Gas Engines 5 Liters +
Diesel Engines up to 2.5 Liters +
JUMP STARTS
Model No. 22s
OWNER’S
MANUAL
Gas Engines
5 Liters +
Diesel Engines up to 2.5 Liters +
JUMP STARTS
JUMP STARTER

2
TABLE OF CONTENTS
Overview................................................................................................3
Getting Started ......................................................................................4
Specs / Charge Up Your Weego 22s ..........................................5
Jump Starting ........................................................................................6
Before You Jump .......................................................................6
Jump Starting Your Engine..................................................... 7-8
Understanding Your Smarty Clamps®......................................9
Troubleshooting .....................................................................10
Engine Compatibility...............................................................11
Important Safety Information ...............................................................12
Weego 22s Optimal Temperature Ranges.................................13
Crazy Long 18-Month Warranty ...................................................... 14-15
WEEGO CUSTOMER SUPPORT
We are dedicated to providing the best possible service. To reach
Weego Customer Support, visit myweego.com/support or email
suppor[email protected].

Smarty Clamps®Have Built-in Safety Protections:
Anti-Spark: The clamps won’t become “live” with power until they are properly
connected to a vehicle battery – this prevents sparks from occurring!
Connection Detection: The green light on the clamps lets you know when you have
a strong, safe connection.
Power Surge: Your Weego 22s is designed to deliver up to 300A of power. The clamps
will cut off power if your engine pulls more than the rated 300A.
Reverse Polarity: If you accidentally reverse the connection of the clamps to your
vehicle battery (positive clamp to negative terminal, etc.) your clamps will let you
know of the error (and won’t jump until you fix it!)
Over-Heat: If your Weego 22s becomes too hot, power will be cut-off (up to 3 min.)
until properly cooled. 3
OVERVIEW
Thank you for choosing Weego Jump Starter 22s! This product was developed to be
powerful, durable and to make jump starting safe & simple. We’re debuting our new jump
starter Smarty Clamps
®
which have advanced safety protections and an easy-to-use
design. Please read all instructions carefully and keep this manual for easy reference.
POWERFUL
• Starts Gas Engines 5L+ Diesel Engines 2.5L+
DURABLE
•Years of staying power - only loses 2% of charge per month when stored
•Over 1000 full charge cycles
•Operating temperature range: -4°F to 140°F
SAFE & SIMPLE Smarty Clamps®
• Unique hinge design allows for an extra-wide opening & easy handling
• Conductive metal on each side of the clamp jaws make for a more
powerful connection
• Intuitive Smart Box guides you through the jump using a series of lights
and sounds
• Small, tapered clamps ideal for tight spaces.

4
GETTING STARTED
Micro USB Charging Cord
Drawstring Carry Bag
Drawstring Carry Bag
Smarty Clamps®
Smarty Clamps®Socket
Battery Indicator Lights
5V/2A Recharge (Input) Port

5
SPECS
JUMP STARTING
Engine Size 5L+ Gas
2.5L+ Diesel
Voltage Compatibility 12V Only
Peak/Cranking Current 1700A/300A
BATTERY
Type Lithium-ion polymer
Capacity 20 Wh
Charge Cycles 1,000
Operating Temp. Range -4°F to 140°F
CHARGE UP YOUR WEEGO 22s
When you unpack your new Weego Jump Starter 22s for the first time, charge
it up to 100% using the Micro USB Charging Cord provided. Make sure you use a
USB enabled wall adapter (like the one
that comes with your smartphone or
tablet) with an output of 2.1A to charge
as quickly as possible (output ratings are
always located on the USB adapter).
It takes 2.5 hours to fully charge when
using a 2.1A USB adapter. The power
indicator lights will ash one by one while
the unit is charging. A solid light indicates
a completed level of charge, while a
blinking light means the level is
progressing. When all 5 lights are solid,
the charging is complete.
Weego 22s will last over a year without recharging, but to keep it topped off,
recharge it every 6 months or so. Weego 22s will allow you to charge & discharge
your unit up to 1000 times, which will give you a good 3-5 years of active use.
Recharge Port
Indicator
Lights
Sequence:
20% Charged
40% Charged
60% Charged
80% Charged
100% Charged

6
Read all instructions and safety information (see pages 12-13) prior to
using this product. Improper use of this product will void your warranty
and may result in product damage, excess heat, toxic fumes, re, and
other unsafe conditions for which Weego is not responsible.
Read vehicle owner’s manual rst: it may have specic cautions
and instructions about jumping your engine.
This product is for use on 12V Lead-Acid batteries only! DO NOT use this
product on any other voltage battery, such as 6V, 24V, etc. DO NOT use
this product on lithium-ion batteries.
Never jump or operate any engine in an enclosed area.
Put your vehicle in PARK and engage the emergency brake (boats and
powersports vehicles should be put in NEUTRAL).
TURN OFF ALL ELECTRONICS! – air conditioner, radio, lights, etc.
Remove any devices attached to your Weego 22.
Never leave your Weego 22s connected to your engine’s battery unless
actively jumping.
Always disconnect the Smarty Clamps®from your Weego 22s when not
in use.
BEFORE YOU JUMP
JUMP STARTING

7
Connect Clamps
Attach Black (-), Then Red (+)
Once it Starts, Disconnect Clamps
from Weego 22
Detach Clamps From Battery
When You Have GREEN LIGHT On Your
Smart Box, Start Your Engine

8
JUMP STARTING YOUR ENGINE
1. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps®to your Weego 22s.
3. Place your Weego 22s in a secure location.
4. Attach BLACK clamp to your battery’s negative (-) terminal, then the RED clamp
to your battery’s positive (+) terminal. Adjust your Smarty Clamps®to achieve
MAXIMUM contact with the terminals. Poor connections will prevent you from
starting your engine! Clear off any dirt or buildup with a wire brush or a dry towel
before connecting your clamps.
5. Check your Smarty Clamps®lights. When you have a GREEN READY light,
start your engine. If the engine doesn’t start, check your Smarty Clamps®
lights and wait a minute before trying again.
6. After a successful start, disconnect the Smarty Clamps®from your Weego 22s.
7. Detach the Smarty Clamps®from the battery.
8. You’re now good to go - be sure to run your engine for at least 15 minutes before
shutting it off again so it has time to recharge your battery.
If you are having issues getting your engine started, see the Troubleshooting
section on page 10 or visit myweego.com/support for further details
and assistance.
WARNING!
Exposed Metal Jaws May Be HOT After Use!

9
READY Solid green light, no Sound
Smarty Clamps®detect that you have a good connection
and you are ready to jump.
Flashing Green & Red Lights + Beeping
REVERSE +/-
You attached the Smarty Clamps®on the wrong terminals.
Make sure the BLACK clamp is attached to the battery’s
NEGATIVE (-) terminal, and the RED clamp is attached to the
battery’s POSITIVE (+) terminal. If not attached properly,
Weego 22s will not let you jump your engine.
COOL DOWN
WAIT FOR
Flashing Red Light + Beeping
The Weego battery overheats after long cranks or excessive
current draw. Detach the Smarty Clamps®from the battery
and give the unit up to 3 minutes to cool down. Then, repeat
steps 2-5 under Jump Starting Your Engine.
Either you have a poor connection, or your battery is so dead
(nearly 0 volts) that your Weego clamps cannot register a
connection.
No Light
This means the vehicle’s battery is too weak to even start, OR
the system voltage of your vehicle is not compatible with your
Weego 22s (for 12V vehicles ONLY).
Solid Red Light, No Sound
There may be an engine size issue. If your engine is larger
than what we recommend, it will try to pull more power than
your Weego 22s is able to give. Please see Engine
Compatibility in the owner’s manual to determine if your
engine size falls within the scope of Weego 22s.
SEE REVERSE
Solid Red Light + Beeping
SEE REVERSE
UNDERSTANDING YOUR Smarty Clamps®
Your Smarty Clamps®have a “smart” box that will help guide you
through a jump with both sight and sound. It will let you know when it
is safe to jump or if there is an error.

10
TROUBLESHOOTING
Visit www.myweego.com/support for FAQs and additional troubleshooting inquiries.
My unit won’t power on/charge/charge past a few lights
If you’re unit won’t power on, won’t take a charge OR won’t charge past a few
lights then it’s been overdischarged. This can happen if the unit is left ON, or if an
engine pulled the Weego battery past a certain limit during a jump start.
Please reach out to [e-mail] to let them know about this issue –
we’ll receive and test the overdischarged Weego, then determine if we can repair
it or if it needs to be fully replaced.
The Weego won’t jump start my vehicle
A few things can attribute to a failed jump start, which we listed below.
For more detail please visit our troubleshooting page at
www.myweego.com/support
• Poor connection between the Weego clamps and vehicle battery:
the better the connection, the more likely you are to have a successful jump
• Dirty battery terminals: build up prevents all the available power from
reaching your battery
• Vehicle-specific compatibility issues: occasionally we come across a vehicle
that has unique power demands that a smaller model cannot fulfill, even
though it’s within our recommended engine range. In addition, vehicles with
heavier electronics can sometimes create issues when jumping with a Weego;
we mostly see this in push-to-start vehicles.
• Cold temperatures: Freezing temperatures create a lot of resistance in an
engine which means it can require up to 3.5X the usual amount of power to
get started; for example, an engine that usually needs 200A could need up to
700A in the extreme cold. In addition, if your Weego was stored in the cold
temps it will make it harder for the Weego to deliver its full power.
• Low-Charged Weego: it’s always best to work with full power on your
Weego if you can. Our jump starters perform better at 100% charge
than they do at 20% charge, especially when jumping larger engines.