Weiking BH600 User manual

Make sure that the headphone is within 10 meters from your
mobile device.
1.Press and hold button for 6 seconds,until you hear “Ready
to pair”and LED indicator fast blinking blue and red.
2.Go to the Bluetooth settings on your mobile device, search and
select “BH600”from the list.
3.Once paired, you hear“connected”and the LED indicator
slowly flashes blue.
1.Before the first use, fully charge the built-in battery.
2.Plug the small end of the USB cable into the USB charging
port on the left earcup. Plug the other end into a USB wall
charger or computer that is powered on.
Foladble ANC Cancelling
Headphone
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
① ANC on/off switch
② ANC LED indicator
③ Mirco USB charging port
④ Battery charging LED indicator
⑤ Volume up/Next track
⑥ Volume down/Previous track
⑦ Aux input jack
⑧ Power/Pairing LED indicator
⑨ BT On/Off/MFB
⑩ Mirophone
Press

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.