Welbilt Manitowoc UDE0065A User manual

Part Number 000014797 Rev02 05/19
Undercounter Ice Machines
Technician’s Handbook
This manual is updated as new information and models are
released. Visit our website for the latest manual.
www.manitowocice.com

Safety Notices
Read these precautions to prevent personal injury:
• Read this manual thoroughly before operating,
installing or performing maintenance on the
equipment. Failure to follow instructions in this
manual can cause property damage, injury or death.
• Routine adjustments and maintenance procedures
outlined in this manual are not covered by the
warranty.
• Proper installation, care and maintenance are essential
for maximum performance and trouble-free operation
of your equipment.
• Visit our website www.manitowocice.com for manual
updates, translations, or contact information for
service agents in your area.
• This equipment contains high voltage electricity and
refrigerant charge. Installation and repairs are to be
performed by properly trained technicians aware of
the dangers of dealing with high voltage electricity
and refrigerant under pressure. The technician
must also be certified in proper refrigerant handling
and servicing procedures. All lockout and tag out
procedures must be followed when working on this
equipment.
• This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
• As you work on this equipment, be sure to pay close
attention to the safety notices in this handbook.
Disregarding the notices may lead to serious injury
and/or damage to the equipment.

nWarning
Follow these electrical requirements during
installation of this equipment.
• All field wiring must conform to all applicable
codes of the authority having jurisdiction. It is
the responsibility of the end user to provide the
disconnect means to satisfy local codes. Refer to
rating plate for proper voltage.
• This appliance must be grounded.
• This equipment must be positioned so that the plug
is accessible unless other means for disconnection
from the power supply (e.g., circuit breaker or
disconnect switch) is provided.
• Check all wiring connections, including factory
terminals, before operation. Connections can
become loose during shipment and installation.
• For a cord-connected appliance, the following must
be included:
• Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
• Unplug from outlet when not in use and before
servicing or cleaning.
• Do not operate any appliance with a damaged
cord or plug, or after the appliance malfunctions
or is dropped or damaged in any manner.
Contact the nearest authorized service
facility for examination, repair, or electrical or
mechanical adjustment

nWarning
Follow these precautions to prevent personal injury
during installation of this equipment:
• Installation must comply with all applicable
equipment fire and health codes with the authority
having jurisdiction.
• To avoid instability the installation area must be
capable of supporting the combined weight of the
equipment and product. Additionally the equipment
must be level side to side and front to back.
• Remove front panel before lifting and installing and
use appropriate safety equipment during installation
and servicing. Two or more people are required to
lift or move this appliance to prevent tipping and/
or injury.
• Do not damage the refrigeration circuit when
installing, maintaining or servicing the unit.
• Connect to a potable water supply only.
• This equipment contains refrigerant charge.

nWarning
Follow these precautions to prevent personal injury
while operating or maintaining this equipment.
• Legs or casters must be installed and the legs/casters
must be screwed in completely. When casters
are installed the mass of this unit will allow it to
move uncontrolled on an inclined surface. These
units must be tethered/secured to comply with all
applicable codes. Swivel casters must be mounted
on the front and rigid casters must be mounted on
the rear. Lock the front casters after installation is
complete.
• Some 50 Hz models may contain up to 150 grams
of R290 (propane) refrigerant. R290 (propane)
is flammable in concentrations of air between
approximately 2.1% and 9.5% by volume (LEL lower
explosion limit and UEL upper explosion limit). An
ignition source at a temperature higher than 470°C
is needed for a combustion to occur.
• Refer to nameplate to identify the type of refrigerant
in your equipment.
• Only trained and qualified personnel aware of the
dangers are allowed to work on the equipment.
• Read this manual thoroughly before operating,
installing or performing maintenance on the
equipment. Failure to follow instructions in this
manual can cause property damage, injury or death.
• Crush/Pinch Hazard. Keep hands clear of moving
components. Components can move without
warning unless power is disconnected and all
potential energy is removed.
• Moisture collecting on the floor will create a
slippery surface. Clean up any water on the floor
immediately to prevent a slip hazard.

nWarning
Follow these precautions to prevent personal injury
while operating or maintaining this equipment.
• Objects placed or dropped in the bin can affect
human health and safety. Locate and remove any
objects immediately.
• Never use sharp objects or tools to remove ice or
frost.
• Do not use mechanical devices or other means to
accelerate the defrosting process.
• When using cleaning fluids or chemicals, rubber
gloves and eye protection (and/or face shield) must
be worn.
DANGER
Do not operate equipment that has been misused,
abused, neglected, damaged, or altered/modified
from that of original manufactured specifications.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
concerning use of the appliance by a person
responsible for their safety. Do not allow children to
play with, clean or maintain this appliance without
proper supervision.

DANGER
Follow these precautions to prevent personal injury
during use and maintenance of this equipment:
• It is the responsibility of the equipment owner to
perform a Personal Protective Equipment Hazard
Assessment to ensure adequate protection during
maintenance procedures.
• Do Not Store Or Use Gasoline Or Other Flammable
Vapors Or Liquids In The Vicinity Of This Or Any
Other
• Appliance. Never use flammable oil soaked cloths or
combustible cleaning solutions for cleaning.
• All covers and access panels must be in place and
properly secured when operating this equipment.
• Risk of fire/shock. All minimum clearances must be
maintained. Do not obstruct vents or openings.
• Failure to disconnect power at the main power
supply disconnect could result in serious injury or
death. The power switch DOES NOT disconnect all
incoming power.
• All utility connections and fixtures must be
maintained in accordance with the authority having
jurisdiction.
• Turn off and lockout all utilities (gas, electric, water)
according to approved practices during maintenance
or servicing.
• Units with two power cords must be plugged
into individual branch circuits. During movement,
cleaning or repair it is necessary to unplug both
power cords.
We reserve the right to make product improvements at
any time. Specifications and design are subject to change
without notice.

Table of Contents
Part Number 000014797 Rev02 05/19 9
General Information
Model Numbers............................... 17
How to Read a Model Number ................ 19
Model/Serial Number Location ............... 19
Warranty ...................................... 20
Warranty Registration ..................... 20
Installation
Location of Ice Machine....................... 21
Ice Machine Clearance Requirements......... 22
Ice Machine Heat of Rejection ................ 22
Leveling the Ice Machine...................... 23
Electrical Requirements....................... 24
Electrical Specifications....................... 24
Water Service/Drains ......................... 26
Water Supply.............................. 26
Cooling Tower Applications................ 27
Maintenance
Detailed Descaling and Sanitizing Procedure
U0140, UF0140, U0190, UF0190, U0240,
UF0240, U0310, UF0310 ...................... 29
Remedial Cleaning ........................ 39
Cleaning the Condenser ................... 41
Removal from Service/Winterization ....... 42
Bin Removal............................... 43
Detailed Descaling and Sanitizing Procedure
UDE0065...................................... 44
Cleaning The Condenser................... 50
Removal from Service/Winterization ....... 51
Detailed Descaling and Sanitizing Procedure
UDE0080...................................... 52
Cleaning The Condenser................... 63
Removal from Service/Winterization ....... 64

10 Part Number 000014797 Rev02 05/19
Operation
Sequence of Operation U0140/UF0140/U0190/
UF0190/UF0240/U0240/U0310/UF0310 ...... 65
Touch Pad Features........................ 65
Ice Making Sequence of Operation ........... 68
Control board Revisions ................... 68
Software revisions......................... 68
Sequence of Operation .................... 69
Control Board Timers ...................... 71
Safety Limits .............................. 72
U0140/UF0140/U0190/UF0190/U0240/
UF0240/U0310/UF0310 Energized Parts Chart
........................................... 74
Operational Checks ........................... 76
Ice Thickness Check ....................... 76
Ice Thickness Adjustment.................. 76
Minimum/Maximum Slab weight .......... 77
Sequence of Operation UDE0065 ............. 78
UDE0065 Energized Parts Chart ............ 80
Ice Thickness Adjustment.................. 81
Sequence of Operation UDE0080 ............. 82
UDE0080 Energized Parts Chart ............ 84
Operational Checks UDE0080................. 86
Siphon System ............................ 86
Water Level ............................... 86
Water Level Check......................... 87
Ice Thickness Check ....................... 88