Weslo WLEX31308.0 User manual

CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Keep this manual
for future reference.
Visit our website at
www.weslo.com
new products, prizes,
fitness tips, and much more!
V
USER'S MANUAL
Model No. WLEX31308.0
Serial No.
Write the serial number in the
space above for reference.
QUESTIONS?
As a manufacturer, we are com-
mitted to providing complete cus-
tomer satisfaction. If you have
questions, or if parts are damaged
or missing, PLEASE DO NOT
CONTACT THE STORE; please
contact Customer Care.
IMPORTANT: You must note the
product model number and seri-
al number (see the drawing
above) before contacting us:
CALL TOLL-FREE:
1-866-699-3756
Mon.–Fri., 6 a.m.–6 p.m. MT
Sat. 8 a.m–4 p.m. MT
ON THE WEB:
www.wesloservice.com
Serial Number
Decal
Meijer.com

2
TABLE OF CONTENTS
WARNINGDECALPLACEMENT ..............................................................2
IMPORTANTPRECAUTIONS ................................................................3
BEFOREYOUBEGIN ......................................................................4
ASSEMBLY ...............................................................................5
HOWTOUSETHEEXERCISECYCLE .......................................................10
MAINTENANCEANDTROUBLESHOOTING ...................................................13
EXERCISEGUIDELINES ...................................................................14
PARTLIST ..............................................................................18
EXPLODEDDRAWING ....................................................................19
ORDERINGREPLACEMENTPARTS ..................................................BackCover
LIMITEDWARRANTY ..............................................................BackCover
WARNING DECAL PLACEMENT
This drawing shows the location(s) of the warning
decal(s). If a decal is missing or illegible, call
the telephone number on the front cover of
this manual and request a free replacement
decal. Apply the decal in the location shown.
Note: The decal(s) may not be shown at actual
size.
WESLO is a registered trademark of ICON IP, Inc.
Meijer.com

3
1. Before beginning any exercise program,
consult your physician. This is especially
important for persons over the age of 35 or
persons with pre-existing health problems.
2. It is the responsibility of the owner to ensure
that all users of the exercise cycle are ade-
quately informed of all precautions.
3. Your exercise cycle is intended for home use
only. Do not use your exercise cycle in a
commercial, rental, or institutional setting.
4. Keep your exercise cycle indoors, away from
moisture and dust. Place your exercise cycle
on a level surface, with a mat beneath it to
protect the floor or carpet. Make sure that
there is at least 2 ft. (0.6 m) of clearance
around your exercise cycle.
5. Inspect and properly tighten all parts regu-
larly. Replace any worn parts immediately.
6. Keep children under age 12 and pets away
from your exercise cycle at all times.
7. Your exercise cycle should not be used by
persons weighing more than 250 lbs.
(113 kg).
8. The pulse sensor is not a medical device.
Various factors, including the user's move-
ment, may affect the accuracy of heart rate
readings. The pulse sensor is intended only
as an exercise aid in determining heart rate
trends in general.
9. Wear appropriate exercise clothes while
exercising; do not wear loose clothes that
could become caught on your exercise
cycle. Always wear athletic shoes for foot
protection while exercising.
10. When adjusting the seat, insert the seat pin
into one of the holes in the seat post. Do not
insert the seat pin under the seat post.
11. Keep your back straight while using your
exercise cycle; do not arch your back.
12. When you stop exercising, allow the pedals
to slowly come to a stop.
13. If you feel pain or dizziness while exercising,
stop immediately and cool down.
14. Use your exercise cycle only as described in
this manual.
WARNING: To reduce the risk of serious injury, read all important precautions and
instructions in this manual and all warnings on your exercise cycle before using your exercise
cycle. ICON assumes no responsibility for personal injury or property damage sustained by or
through the use of this product.
IMPORTANT PRECAUTIONS
Meijer.com

4
Congratulations for selecting the new WESLO®
PURSUIT S 2.8 exercise cycle. Cycling is one of the
most effective exercises for increasing cardiovascular
fitness, building endurance, and toning the body. The
PURSUIT S 2.8 exercise cycle offers a selection of
features designed to let you enjoy this healthful exer-
cise in the convenience and privacy of your home.
For your benefit, read this manual carefully before
you use the exercise cycle. If you have questions
after reading this manual, please see the front cover
of this manual. To help us assist you, note the product
model number and serial number before contacting
us. The model number and the location of the serial
number decal are shown on the front cover of this
manual.
To avoid a registration fee for any service needed
under warranty, you must register the exercise
cycle at www.wesloservice.com/registration.
Before reading further, please review the drawing
below and familiarize yourself with the labeled parts.
Resistance Knob
Seat
Seat Knob
Pedal/Strap
Console
Thumb Pulse Sensor
Handlebar
BEFORE YOU BEGIN
Meijer.com

5
M8 Split
Washer (42)–9
M8 Locknut
(10)–6
M8 x 15mm Button
Screw (34)–3
M8 x 60mm Button
Screw (30)–4
M8 x 65mm Button
Bolt (50)–2
M8 x 73mm Button
Screw (33)–2
M4 x 16mm
Screw (46)–4
ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tools, assembly requires a Phillips screwdriver , an adjustable
wrench , and pliers .
As you assemble the exercise cycle, use the drawings below to identify the small parts used in assembly. The
number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of
this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small
parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been pre-
assembled.
Meijer.com

6
1.
Insert the Rear Stabilizer (6) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 60mm
Button Screws (30).
6
30
1
2. Orient the Front Stabilizer (2) with the large
holes facing the Frame (1). Attach the Front
Stabilizer to the Frame with two M8 x 73mm
Button Screws (33).
1
1
2
33
2Large
Holes
To make assembly easier, read the
information on page 5 before you begin
assembling the exercise cycle.
3. Attach the Seat (12) to the Seat Post (5) with
four M8 Split Washers (42) and four M8
Locknuts (10). Note: The Split Washers and
the Locknuts may be preattached to the
underside of the Seat.
3
12
5
42
42
42
10
10
Meijer.com

7
4. Turn the Seat Knob (9) counterclockwise and
remove it from the Frame (1). Next, insert the
Seat Post (5) into the Frame. Adjust the Seat
Post to the desired height and insert the Seat
Knob through the indicated hole in the Frame
into one of the adjustment holes in the Seat
Post. Then, turn the Seat Knob clockwise until it
is tight. Make sure the Seat Knob is firmly
engaged in one of the adjustment holes in
the Seat Post.
4
5
1
9
Hole
Adjustment
Holes
5
5. While another person holds the Upright (13)
near the Frame (1) as shown, connect the
Extension Wire (23) to the Reed Switch Wire
(39). Next, connect the Resistance Cable (19)
to the Lower Cable (29) in the following way:
•See drawing A. Pull up on the metal bracket
on the Lower Cable (29), and insert the tip of
the Resistance Cable (19) into the wire clip
inside of the metal bracket as shown.
•See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket as shown.
•See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Push the Wires (23, 39) and the Cables (19, 29)
downward into the Frame (1).
Next, insert the Upright (13) into the Frame (1).
Do not pinch the wires and cables. Attach the
Upright with three M8 x 15mm Button Screws
(34) and three M8 Split Washers (42).
ABC
29
19
19 Metal
Bracket
Metal
Bracket
Do not pinch
the wires and
cables during
this step
34
39
19
29
42 34
23
13
1
42
Meijer.com

8
6. Attach the Handlebar (49) to the Upright (13)
with two M8 x 65mm Button Bolts (50), two M8
Split Washers (42), and two M8 Locknuts (10).
6
50
49
13
10
42
42
8. While a second person holds the Console (16)
near the Upright (13), connect the console wire
to the Extension Wire (23). Then, insert the
wires downward into the Upright.
Attach the Console (16) to the Upright (13) with
four M4 x 16mm Screws (46). Do not pinch
the wires.
8
Do not pinch the
wires during this
step
23
46 13
Console Wire
16
7. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the battery cover, insert the bat-
teries into the battery compartment, and reat-
tach the battery cover. Make sure to orient the
batteries as shown by the diagram inside
the battery compartment.
7
Batteries
Screw Battery
Cover
16
Meijer.com

9
10. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
9. Identify the Left Pedal (24), which is marked
with a “Left” sticker. Using an adjustable
wrench, firmly tighten the Left Pedal counter-
clockwise into the left arm of the Crank (21).
Tighten the Right Pedal (not shown) clockwise
into the right arm of the Crank. IMPORTANT:
Tighten both Pedals as firmly as possible.
After using the exercise cycle for one week,
retighten the Pedals. For best performance,
keep the Pedals tightened.
Adjust the strap on the Left Pedal (24) to the
desired position, and press the end of the strap
onto the tab on the side of the Left Pedal.
Adjust the strap on the Right Pedal (not shown)
in the same way.
9
24
Strap
Tab
21
Meijer.com

HOW TO AD UST THE SEAT POST
For effective exer-
cise, the seat should
be at the proper
height. As you pedal,
there should be a
slight bend in your
knees when the ped-
als are in the lowest
position. To adjust
the height of the
seat, first turn the
seat knob counter-
clockwise and
remove it. Next, slide
the seat post upward
or downward and align one of the adjustment holes in
the seat post with the indicated hole in the frame.
Then, insert the seat knob into the frame and the seat
post, and turn the seat knob clockwise until it is tight.
Make sure that the seat knob is inserted through
one of the adjustment holes in the seat post.
HOW TO AD UST THE PEDALING RESISTANCE
To increase the
resistance of the
pedals, turn the
resistance knob
clockwise; to
decrease the resis-
tance, turn the resis-
tance knob counter-
clockwise. IMPOR-
TANT: Stop turning
the knob when turn-
ing becomes diffi-
cult, or you may
damage the exercise cycle.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle
rocks on your floor
during use, turn one
or both of the level-
ing caps until the
rocking motion is
eliminated.
HOW TO USE THE EXERCISE CYCLE
10
Seat Post
Seat Knob
Hole
Seat
Leveling
Caps
Resistance
Knob
Meijer.com