Operating Instructions: 9610A - Brick LED Light, Rev.A Page: 3 of 4
Western Technology, Inc., 3517 Arsenal Way, Bremerton, WA 98312
Telephone: 800-654-5483; www.westerntechnologylights.com
1. It is recommended that you implement a standard monthly or more frequent
preventive maintenance schedule for 9610A Brick LED Lights and accessories.
Safety requires a thorough visual examination of the unit for physical damage that
might cause a spark or result in the ignition of hazardous atmospheres.
Maintenance includes a careful examination to ensure at least that:
A. The 9610A Brick LED Light Body is not cracked, broken or breeched.
B. The Lens is not cracked or chipped.
C. The Braided Cable Strain Reliefs are not frayed and are gripping the Cable
tightly in all points of cable contact.
D. The Cable Jacket is completely intact and that no internal conductors or
conductor insulation is exposed.
E. The Connection Box is not cracked, broken or breeched.
F. The Cord Plug is not cracked or damaged and the Ground Post is intact.
G If your light has the MDCM processor (option) installed, please see separate
instructions.*
*Note: The 9610A Brick is available with an optional Integrated Maintenance Duty
Cycle Monitoring™(MDCM) processor which can be used to signal required
preventive maintenance examination of the equipment. Contact Western
Technology for more information
2. For your safety and to maximize the life of the 9610A Brick LED Light –
Avoid rough usage such as:
A. Pulling the 9610A Brick LED Light or Connection Box by the Cable, which
could weaken or damage the Cable. Move or carry holding ONLY the
handle.
B. Severely bending the Cable at any point, especially the Strain Reliefs.
Repeated bending will both damage the Strain Relief braiding, which
weakens its grip strength on the Cable; and may ultimately breech the Cable
jacket allowing the internal conductors to fail.
C. Impacting the lens with hard, sharp or heavy objects, which will cause the
lens to scratch, chip, crack, or shatter.
D. Setting the 9610A Brick LED Light FACE DOWN, especially on abrasive
surfaces, which might result in chipping, scratching, abrading or cracking of
the Lens.
E. Operation of the 9610A Brick LED Light without the Bumpers.
F. Disconnecting the Cord Plug from the receptacle by pulling on the Cable.
3. Keeping the 9610A Brick LED Light clean and free of material splatter, overspray,
and debris during usage will ensure the maximum life and luminosity of the light.
