whi SBLY 1403 Instruction sheet

Thank you for purchasing this WHI Safeguard Product.
It is essential that you read these instructions
carefully before operating this product for the
first time.
Please retain these instructions for future reference.
The illustrations shown are for illustrative purposes only.
Scaffolding & Barrier
Safety Lamp
Scaffolding Bulkhead
Safety Lamp
Side Mount
PRODUCT INSTRUCTIONS
1. Installing / Removing Batteries
1. Remove screws from the underside of the
lens body with your screwdriver and lift the lens
two inches.
2. Grip, twist and pull battery cap away from the base.
3. Insert two AA batteries as featured.
4. Align the lip and groove, then replace battery cap.
Twist to secure cap.
5. Replace lens and secure screws.
2. On/Off Button
1. Press once to activate flashing light, press
twice for static and a third time to switch off.
WHI Safeguard’s innovative lighting solution is designed
to fit quickly and securely to all types of scaffolding and
other industrial applications. The product provides a
simple, robust and tamperproof solution to the increasing
need to clearly illuminate scaffolding and construction
areas. This photocell activated product provides 360
degree flashing light with prolonged battery life.
+
+-
-
TECHNICAL DETAILS
Model No.
SBLY 1403
BHYR 1405 / BHYW 1405
* Uses 2 x AA standard Alkaline batteries (not included)
* Illumination Type - LED x 4, yield of minimum 1100 mCd
* Flash Pattern - 30 per minute (single flash)
* Duration of Flash - 200 Milliseconds
Do not short-circuit battery terminals.
Do not allow any part to come into contact with
heat or a direct flame.
Do not allow water to come in contact with
batteries or wiring.
For maximum performance, use good quality
batteries.
Phillips screwdriver required for battery
installation.
WARNING: This product is not a toy.
Keep out of reach of small children and pets.
Do not look directly at the LED Lights.
At the end of its useful life, batteries must be
removed from the product and disposed of
appropriately.
ON / OFF Button
Note the correct polarity (+ or -).
Groove

3. Installing light module
4. Position the light
Place in position with the lens at the top,
then fasten with the security screws and
tool provided.
We warrant the product against defects in materials and workmanship,
under ordinary consumer use, on delivery and for a period of 12 months from
the date of delivery. If the product proves defective during the warranty
period, we will ask you to follow the instructions for returning the product
that we will provide you with, and we will take one of the following actions:
(1) Replace the product with one that is the same or equivalent to the
product you purchased; (2) Repair the product; (3) Refund to you the
whole of or part of the purchase price of the product. Due to product
advancement and product availability, the replacement product may differ
slightly and may have a lower selling price from the original product you
purchased. Made In China.
Warranty Information Manufacturer Address
WHI Safeguard Limited
Meryll House, 57 Worcester Road
Bromsgrove, B61 7DN, England.
T. 44 (0) 1753 325 101
E. [email protected]
WHI Safeguard is a registered trademark
Insert the light module and twist into position, then fasten
security screw from the underside with the tool provided.
The module must be positioned with the grooves to
fasten securely.
Align and position the lips on
the bottom of the module
with the grooves in the base.
PLEASE NOTE