Whirlpool LE7000XS User manual

I
I
II
AUTOMATIC
DRYERS
Electric Model
LE7000XS
and
Gas Model
LG70OIXS

Parts and features
CYCLE CONTROL KNOB
I LeUNDRY INFORMATION CENTER
TEMPERATURE SELECTOR
BUllON
LINT SCREEN
I( /DRYER DRUM
DOOR
MODEL
AND SERIAL
NUMBER PLATE
LA+
Copy your Model and Serial Numbers here
Remove the Con-
sumer Buy Guide label
before using your
dryer. It will be easier
to remove.
Wipe out the dryer
drum with a damp
cloth to remove dust
from storing or ship-
ping.
When you need service or call with a
question, have this information ready:
1. Complete Model and Serial Numbers
(from the plate located as shown).
Model Number
2. Purchase date from sales slip.
Copy this information in these spaces. serial Number
Keep this book in the Laundry Information
Center with your “Dryer Guide:’ sales slip
and warranty Purchase Da+e
Please complete and mail the Owner
Registration Card furnished with this Service Company
product.
Telephone Number
Contents
Page Page
PARTS AND FEATURES 2 Drying Times 8
IMPORTANT SAFETY Mixed Loads.. 8
INSTRUCTIONS. 3 End-of-Cycle Signal . 8
OPERATING INSTRUCTIONS. 4 Lint Signal 8
Selecting a Cycle and LINT SCREEN . 9
Starting Your Dryer 4 LINT REMOVAL.. . . . 9
Automatic Cycles. 6 CARING FOR YOUR DRYER.. 10
Timed Drying 6 Cleaning Dryer Interior.. . . . . 10
DRYING TIPS 7 Vacation Care . 10
FLUFFAIR Setting 7 IF YOU NEED SERVICE OR
TUMBLE PRESS@Setting 7 ASSISTANCE . . . 11
Automatic DRY-MISER@ WHIRLPOOL DRYER
Control . . . . 7 WARRANTY . . .
12
Gentle Heat. . . . 7
01987 Whirlpool Corporation
2

ALWAYS shut off the gas valve before
leaving on vacation.
NEVER use or store flammable fluids
(dry-cleaning solvents, gasoline, ker-
osene) in or near Your dryer. These sub-
stances give off vapors that can create
a FIRE HAZARD or EXPLOSION.
NEVER operate the dryer if...
l it is not working right (i.e. noisy, too hot].
l it is damaged.
l parts are missing (i.e. door latch].
l all panels are not in place.
l the lint screen is loose, damaged or
missing.
. FOR YOUR SAFETY.
IF YOU SMELL GAS:
1. OPEN WINDOWS.
2. DON’T TOUCH ELECTRICAL SWITCHES.
3. EXTINGUISH ANY OPEN FLAME.
4. IMMEDIATELY CALL YOUR GAS
SUPPLIER.
ALWAYS unplug the power supply cord
or turn off electrical power before at-
tempting to service the dryer. Shut off
GAS VALVE if Yours is a gas dryer.
You are personally rerponslble tor
maklng sure that your dryer...
l is properly maintained.
l is properly installed and leveled in a
well ventilated room* on a floor that
can support the weight.
l is located in an area where the tem-
perature is above 45°F (7.2”C).
l is connected to the proper outlet and
electrical supply.*
. is properly connected to fuel and ex-
haust systems:
l is not installed against drapes or
curtains.?
l is used only for jobs normally ex-
pected of home clothes dryers.
l is not used by children or anyone un-
able to operate ii properly.
*See “lnstallatlon Instructions” tor
complete information.
3

SUGGESTED SUGGESTED
TYPE OF LOAD CYCLE TEMPERATURE
COTTONS - LINENS HEAVY
EXTRAHEAVY- Bedspreads, HIGH
mattress pads, quilts . . . . . . . . . .
HEAVYWEIGHTFABRICS- Towels,
jeans, corduroys, work clothes
MEDIUMWEIGHTCOTTONS-
Sheets, pillowcases, cotton AUTOMATIC PERM’TPRESS
REGULAR MED
underwear, diapers . . . .
LIGHTWEIGHTCOTTONS- Batistes,
organdies, lingerie . . . . . . . . . . . . . . . . . .
PERMANENT PRESS, SYNTHETICS
AND BLENDS
HEAVYWEIGHTFABRICS-Work clothes,
jackets, raincoats . . . . . . . . . . .
MEDIUMWElGHTFABRICS-Shirts, play
clothes, sheets, slacks. . . . . . . .
LIGHTWElGHTFABRICS- Lingerie,
blouses, dresses . . . . . . . . . . . .
KNITSGENTLE
LOW
PERM’TPRESS
AUTOMATIC MED
PERMANENT
PRESS MED LOW
KNITS
HEAVYWEIGHT-Cottons, rayons,
blends, T-shirts,slacks, shirts . . . . .
LIGHTWEIGHT- Synthetics (polyester,
acrylic, etc.] and blends, lingerie,
blouses, dresses . . . . . . . . .
LIGHTWEIGHT AND DELICATE FABRICS
Sheer Curtains (2 or 3 panels)
Gauze, lace, etc. . . . . . . . . . . . . . . . . . . .
MED LOW
AUTOMATIC
PERMANENT
PRESS KNITSGENTLE
LOW
AUTOMATIC
PERMANENT DCLOW
PRESS
RUBBER, PLASTIC, HEAT-SENSITIVE
FABRICS
FOAM RUBBER- Pillows, bras,
stuffed toys . . . . . . . . . . . . . . . . .
PLASTIC- Shower curtains,
tablecloths............................
RUBBER-BACKEDRUGS . . . . . . . .
FLUFF Ex LOW
AIR

1
. Select a CYCLE
Turn the Control Knob either way to
point to the cycle and setting you
want. See page 6 for information on
the cycles.
3
. Push the STARTButton
The dryer will start tumbling when you
push the STARTButton.
Ifthe STARTButton is pushed when the
Cycle Control Knob is pointing to an
OFF area, the End-of-Cycle Signal will
sound. Dryer will not start.
2
Set
. TEMPERATURESELECTOR
The Temperature Selector can be set
on any desired temperature or any-
where between 2 temperatures.
To stop and restart
the dryer
To stop the dryer, open the door (or
turn the Control Knob to OFF).
To restart the dryer, close the door,
Seled Cycle, if necessary, and push
START.
The Cycle Control Knob should point to an OFF area when the dryer is
not In use. If the dryer Is stopped before the cycle is finished, turn the Cycle
Control Knob to an OFF area. 5

The automatic cycles
The automatic cycles allow you to se-
lect the degree of dryness you prefer
for the clothes being dried.
The Control Knob will not move until
the clothes load is almost dry, or the
COOL-DOWN portion of the cycle has
been reached. After COOL-DOWN, the
knob automatically moves to an OFF
area and tumbling stops.
weight cotton items. The load tumbles
wlthout heat durlng the last 5 mln-
utes. This helps make the load easier
to handle.
Use
AUTOMATIC
PERMANENT
PRESSto dry
oermanent
press, knits and other synthetic fab-
rics. The load tumbles without heat
during the last 10 minutes. This helps
keep wrinkles from setting in, and
makes the load easier to handle.
For the first few loads, set the Control
Knob to point to an * in either auto-
matic cycle. When the dryer stops, feel
the dried items.
l If items are drier than you like, use
a setting to the right of the * the next
time YOU drv a similar load.
l If items are not as dry as you like, use
a setting to the left of the * the next
time you dry a similar load.
Timed drying
Use the TIMED DRYING Cycle for
any load you want to dry by time.
l Turn the Control Knob to the number
of minutes you want-from 10to 70.
l The last 5 minutes of this cycle are
without heat - a cool-down time.
This helps make the load easier to
handle.
6

Drying tips
The dryer does not heat when the
Control Knob is set on FLUFFAIR. This
setting can be used to fluff bedding,
plastic tablecloths, foam rubber
pillows, stuffed toys, sneakers, etc.
4. Turn the Control Knob to the number
of minutes you want in FLUFFAIR.
2. Push the STARTButton.
Automatic DRY-MISER”
Control
The thermostat senses the air
temperature. The dryer automatically
shuts off when the selected dryness
is reached.
TUMBLE PRESS” Setting
The TUMBLE PRESSsetting removes
wrinkles from dry clothingsuch as
items that may have been packed
in a suitcase, closet, or items not
removed from the dryer.
1. Set Control Knob to TUMBLE PRESS.
2. Set Temperature Selector to PERM’T
PRESQMED.
3. Push STARTButton.
The load will tumble in heated air
for 15minutes. The heat shuts off and the
dryer continues to tumble the load
for 5 more minutes.
For best results, TUMBLE PRESSonly a
few items at a time. Put them on hang-
ers or fold them as soon as the dryer
stops.
Gentle Heat
The dryer automatically reduces
the heat settings in HEAVY HIGH and
PERMIT PRESSMED cycles. During
the last few minutes of each of
these cycles the dryer temperature
gradually reduces to a lower heat
setting. This helps prevent
overdrying.

Drying times Mixed loads
Drying times will vary depending on:
l amount of moisture in the clothes.
l type and weight of the fabric.
l size of the load.
l room temperature around the dryer.
l temperature of the wash rinse water.
l amount of lint in the lint screen.
l dryer temperature selection.
See your “Dryer Guide” for
more information.
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested for the lightest fab-
rics. When the dryer stops, remove dry
items and reset the control.
End-of-cycle signal
The dryer sounds a signal to let you know when
the cycle is finished. The signal cannot be turned
off and is not adjustable.
The signal is helpful when you are drying per-
manent press, synthetics and other items that
should be taken out as soon as the dryer stops.
Clean lint screen before each load. If you
neglect to clean your lint screen, the signal will
sound. The (whistle tone) signal lets you know
the air flow is being restricted. Restricted air flow
reduces drying efficiency.
Turn off the dryer and clean the lint screen as
shown on page 9.

Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time and may be a FIREHAZARD.
Open the lid and pull the lint screen
straight out. ROLL the lint off the screen with
your fingers.
DO NOT rinse or wash the screen.
Push the screen firmly back into place.
Lint removal I
Lint can gather inside the dryer and create a FIRE HAZARD. This lint
should be removed at least every 2 to 3 years, or more otten, depending
on dryer usage. I
ELECTRIC DRYERS GAS DRYERS
Cleaning should be done only by a qualified person.
WARNING:
l Avoid electrical shock
hazard - unplug power
supply cord or turn off
electrlcal power.
l Avoid inJury or damage-do not
put hands Inside cabinet.
l Make sure dryer is cool.
1. Remove back panel (electric)
or lower access panel (gas).
2. Avoid damaging wires,
thermostats, funnel or igniter.
3. Remove lint from shaded area - I
see art-with a soft brush or
vacuum cleaner. I
4. Replace panel; reconnect and
_- ,___^I A- ,^_
rc3tww uryar

Remove loa and sharp objects
from pockets and cuffs before drying -
pins, buckles, etc. Close metal
Some pretreatment products can
damage dials, consoles and finish.
Do not use these products on or near
your dryer. \
Wlpe off all spills with a damp, soft
cloth. Spills allowed to remain may
dull or damage the finish.
Never leave wet or damp laundry
in your dryer.
Sharp or heavy objects should
never be put on or in the dryer.
Check pockets for bolts, nuts etc.
Cleaning dryer interior
WARNING: Before
cleaning lnterlor, unplug
power supply cord or,
turn off electrlcal power to
avold electrical shock hazard.
Garments which contain unstable
dyes, such as denim blue jeans or
brightly colored cotton items, may
discolor the dryer interior. Ifthe
interior is discolored, clean with
one of the following methods to
avoid staining later load items.
Powdered laundry detergent and
very warm water
Make a paste with detergent and
very warm water. Apply paste to
a soft cloth and scrub area until
all excess dye is removed. Wipe
thoroughly with a damp cloth.
Tumble a load of rags. -OR-
liquid spray household cleaner
Spray on stained area. Rub with
a cloth until all excess dye is
removed. Tumble a load of rags.
Vacation care
l Unplug power cord or turn off
electrical power.
l For gas dryers, close gas valve.
l Clean lint screen.
10