®30" Drop-in Electric Range
PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
COUNTERTOP PREPERATION
RS610PXG
RS675PXG
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Electrical: Connect with 8-gauge solid copper
wire. Models rated from 11.8 kW to 13.3 kW at
240 volts (8.9 kW to 10.0 kW at 208 volts) require
a separate 40-ampere circuit, fused on both sides
of the line. A separate circuit is required. A time-
delay fuse or circuit breaker is recommended.
30-3/4"
recessed
height
from
underside
of cooktop
to support
slats
28-3/16"
cooktop
recessed width
23-1/8"
recessed
depth
shipping
foot
31-11/16"
overall
height
30"
overall
width
28-5/32" oven
recessed width
31-1/2"
overall
cooktop
width
21"
cooktop
depth
24-13/32"
to back
of oven
30”
7/8" min.
required
between
cutout and
cabinet door
or hinge.
Locate electrical
supply junction
box on cutout
floor or on rear
wall (shown)
near floor line.
Front view of
cabinet cutout
For minimum
clearances to the top
of cooktop see Note.*
* Note: 24" min. when bottom of wood or metal
cabinet is protected by not less than 1/4" flame
retardant millboard covered with not less than No.
28 MSG sheet steel, 0.015" stainless steel, 0.024"
aluminum or 0.020" copper.
30" min. clearance between the top of the cooking
platform and the bottom of an unprotected wood
or metal cabinet.
wall
1-1/8"
max.
13" max. upper
cabinet depth
19-5/8"
25" countertop
depth
24" lower
cabinet depth
floor
cabinet
front
Side view of
cabinet cutout
1-1/2" max.
countertop
thickness To p v i ew of
cabinet cutout
Install a 3-1/2"-wide support slat on
each side. Slats must be level front
to back and with each other.
30-3/4"
top of
countertop to
support slats
28-1/2" min.
opening width
28-5/8"
opening is
recommended,
if available.
36" overall
countertop
height
1/4"
radius both
corners
Front edges: You may need to shave or cut the
trim of formed or metal front-edged
countertops to clear the 30" width of cooktop.
If countertop thickness is more than 1-1/2"
inches thick: Countertop must be notched as
shown to avoid damaging the oven control panel.
If countertop extends more 1-1/8" beyond
cabinet front: Notch countertop as shown to
clear oven control panel.
30-1/8"
notch width
to be equal
both sides
notch width
to be equal
both sides
1-1/2"
max
30-1/8"
1-1/8"
max
cabinet
front
Top of countertop
Note: countertop
must be level
across front and
front to back.
30-3/4"
top of
countertop
to bottom
of cabinet
cutout
Ref. 8300649
02-26-03
