Whirlpool LA546OXP User manual

\‘.‘..i:r::::::-::::-:-;:-
AUTOMATIC
WASHER
Design 2000
fW,CaPacity
LA546OXP
Owave Ovens. Trash Compactors, Room Air Condltloners, Oehumtdlfws, Automatic Washers, Clothes Oryers, Freezers. Refngerator-Freeze

Parts and features
LAUNDRY TEMPERATURE
SELECTOR
fi / KNOB
MAGIC CLEAN@
LINT FILTER
(not shown)
MODEL AND SERIAL
NUMBER PLATE
(not shown)
AGITATOR
- BASKET
TUB
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When youneed service or call with a
question, have this information ready: Model Number
1. Complete Model and Serial Num-
bers(from plate underthe lid nearthe
hinge). Serial Number
2. Purchase date from sales slip
Copy this information in these spaces. Purchase Date
Keep this book in the Laundry Informa-
tion Center with your “Laundry Guide,” service
Company/
sales slip and warranty. Phone Number
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
2

Your :sponsibilitie s
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l is installed by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight.*
l is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l is properly grounded.-
. is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the “Installation InStrUCtiOnS”
for complete information.
Contents
Page
PARTS AND FEATURES. 2
YOUR RESPONSIBILITIES.. 3
SAFETY FIRST 3
STARTING YOUR WASHER 4
WHAT HAPPENS IN EACH
CYCLE. 6
OTHER OPERATING
INSTRUCTIONS 8
For a Rinse and Spin 8
For a Drain and Spin 8
MAGIC CLEAN8 Filter
CARING FOR YOUR WAiitER 8
9
Winterizing 10
IF YOU NEED SERVICE OR
ASSISTANCE. 11
I. Before Calling for
Assistance 11
2. If You Need Assistance 11
3. If You Need Service It
4. If You Have a Problem 11
01984 Whirlpool Corporation -SAVE THESE INSTRUCTIONS -

Starting your washer
Before starting your washer:
1. Measure and add detergent.
2. Place sorted load in washer.
-
3. Start wa
Select a Select WATER
1. LOAD SIZE
2. TEMPERATURES
l The water level can be set for SMALL
(a few items] or LARGE [a full load).
l Match the wash water temperature
to the type of fabrics and soils being
washed.
NOTE: Use the LARGE water level
for best permanent press results.
l All rinses are cold. Cold rinses
save energy and help prevent
wrinkles from settina into fabrics.
I
DO NOT LOAD
ABOVE CLOTHES GUARD
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
DO NOT
OVERLOAD W
8
*Approximate
fill with load.
LARGE (17.2 gals./651
SMALL (9.5 gals./360
&HER.
4

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What happens in each cycle*
Each cycle has been designed for different kinds of fabrics. Numbers on the
dial in each cycle are the minutes of WASH agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before agitation and timing starts. After agitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends.-
REGULAR HEAVY Cycle
REGULAR Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled,
A cycle for regular loads of
fabrics that are moderately
soiled.
PERMANENT PRESS Cycle
SHORT Cycle
A special cycle with the
necessary cool down rinse
which helps keep wrinkles
from setting into Permanent
Press and some synthetic
fabrics.
Use for delicate items that
need a short wash and
spin time. Wash nylon hose
or panty hose in a net
laundry bag.
6

NOTE: You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to help
1 DRAIN h 1 FILL RINSE I DRAIN 81I
m
1DRAIN & I
1 SPIN 1
I ASprav
I I
Rinses

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. [Extra de-
tergent can require an extra rinse.]
l Push Control Knob in.
l Turn clockwise to any. on the dial.
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
l Push Control Knob in.
l Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l Pull Control Knob out.
l The washer will drain and spin.
MAGIC CLEAN@ lint filter
The lint filter in your washer cleans itself. Collected
lint is drained away with the wash and rinse Water.
If your washer drains into a tub, remove any lint
collected in the drain or strainer.
8

Caring for your washer
OF
WHEN NOT WASHING, keep both
water faucets turned off. This takes
the pressure off the water inlet valVe
and hoses.
REMOVE SHARP OBJECTS such as pins,
buckles, etc., from clothes before
washing. Close metal zippers.
AFTER WASHING, use a soft dry cloth
to wipe the outside and inside dry.
Leave the lid up until the basket is dry.
Wipe up spills right away. Spills can
dull or damage the finish.
SHARP OR HEAVY OBJECTS should
never be put on or in the washer.
Check pockets for bolts, nuts,
tools, etc.
SOME PRETREATMENT PRODUCTS
can damage washer and dryer dials
consoles and finishes. Do not use
these products on or near your
washer or dryer.

Winterizing
Because some water stays in the washer, freez-
ina can cause a lot of damage. If your washer is
stored or moved during the cold weather
1. Shut off both water 2. Put a quart of
faucets. Discon- automobile-type
nect and drain antifreeze in the
water inlet hoses. basket.
3. Set the washer for a
DRAIN and SPIN
(see page 8). Let it
run for about 30
seconds to mix the
antifreeze and
water.
4. Run the washer
through a com-
plete cycle with
To use the washer again.. .
one cup of deter-
1. Flush water pipes and hoses. gent to clean out
2. Connect hoses to the washer. the antifreeze.
3. Turn on the water faucets.
10