Whirlpool LA6400XP User manual

AUTOMATIC
WASHER
Design 2CKKl”
Large Capacity
Model
,’ LA64ooXP
wave Ovens Trash Compactors Room Air Condftloners. Dehumldlflerr Automatic Washers Clothes Dryers. Freezers. Aelrlgerator-Freeze

Parts and features
LAUNDRY TEMPERATURE MAGIC CLEAN”
LINT FILTER
(not shown)
MODEL AND SERIAL
NUMBER PLATE
(not shown)
IQUID BLEACH
DISPENSER
\
- LIQUID FABRIC
SOFTENER DISPENSER
. AGITATOR
.BASKET
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready: Model ‘\rumbel
1. Complete Model and Serial Num-
bers (from plate underthe lid near the ---..~---...
Serial Number
hinge].
2. Purchase date from sales slop --~..
Copy this information in these spaces. P’rcha’e Date
Keep this book in the Laundry Informa-
tion Center with your”Laundry Guide,” -~
Service Company
sales slip and warranty.
Phone Number
2

Your responsibilities
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
informatron.
You are personally responsible
for making sure that your
washer..
l is instulled by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight.+
l is connected to the right kind
of outlet, electric supply, water
supply and drain.’
l is properly grounded.’
l is used only for jobs normally
expected of home automatic
washers
l IS properly maintained.
l IS protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
See the “Installation Instructions”
for complete information.
Contents
PARTS AND FEATURES 2
YOUR RESPONSIBILITIES 3
SAFETY FIRST 3
STARTING YOUR WASHER 4
WHAT HAPPENS IN EACH
CYCLE 4
OTHER OPERATING
INSTRUCTIONS 10
For a Rinse and Spin 10
For a Drain and Spin 10
For a Soak or Pre-Wash 10
Llqurd Bleach Dispenser 11
Fabric Softener Dispenser 11
MAGIC CLEAN ’ Lint Filter 11
CARING FOR YOUR WASHER.. 12
Winterizing
IF YOU NEED SERVICE’& 13
ASSISTANCE.. 14
1 Before Calling for
Assjstance 14
2 If You Need Assistance 15
3 If You Need Service.. 15
4 If You Have a Problem 15
c 1986 Whirlpool Corporation

Starting your washer
1 Measure (2nd add detergent
2 Place sorted load In washer
3 Start washer
Select a
1. LOAD SIZE Select WATER
2. TEMPERATURES
l Turn the knob to pint at a setting
that describes the size of load you
want to wash.
l Set the knob on or between
EX SMALL [a few items] and
LARGE [a full load].
l Match the wash watertemperature
to the type of fabrics and soils being
washed
l All rinses are cold.
Recommended wash temperatures
can be found in your “Laundry Guide’:
NOTE: Use the LARGE water level
for best permanent press results.
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items. ~
CAUTION :
DO NOT
OVERLOAD WASHER.
*Approximate
fill with load.
(17.3 gals./655 L)’
(14.7 gals./557 L)’
(12.1galsI45.8 L)’
(9.5 gaW36.0 L)’

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What happens in each cycle*
Each cycle has different agitation and spin speeds designed for different
kinds of fabrics. Numbers on the dial In each cycle are the minutes of WASH
agitation time.
When the Cycle Control Knob ISset to a number and pulled out, the washer
fills before aaitation and timrna starts. After aaitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends -
REGULAR HEAVY Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled
REGULAR Cycle
A cycle for regular loads of
fabrics that are moderately
soiled.
PERMANENT PRESS Cycle
L \I
nn
FILL
t0
u
Selected
Level
A special cycle with the
necessary cool down rinse
which helps keep wrinkles
from setting into Permanent
Press and some synthetic
fabrics.
n-
WASH WASH
Minutes
Hiih 1 ric 1
Speed
6

WASH
6
u
Minutes
LOW
Speed
NOTE: You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to help
with the nnsing
1 WASH 1
High
Speed

KNITS/GENTLE Cycle
A cycle that gently washes
and spins delicate items
and washable knits
11
SO.4K AND PRE-N:,\SH C’>,cles
Brief periods of agitation
and soak time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
mended amount of
detergent or pre-soak
additive. The SOAK Cycle
should always be fol-
lowed by a Wash Cycle.

SOAK
4
Minutes
No
4gitation
)
STClra
I Select
L
Wash
Cycle
I
+Pre-wash setting begins here, (see pagelo].
Special care is needed when soaking or pre-washing laundry.
See your “Laundry Guide” for proper use of this cycle.

Other operating instructions
For a rinse and spin
4
For a drain and spin
You may need an extra rinse ond
spin for heavily soiled loads whrch
need more detergent [Extra de-
tergent can require an extra rinse ]
l Push Control Knob In.
l Turn clockwlse to any* on the dial
See above drawing.
. Pull Control Knob out
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin
Your washer can be set to drain
and spin out water
. Push Control Knob In
. Turn clockwlse to the bar just before
OFF in any cycle See above
drawing
l Pull Control Knob out
l The washer WIII drain and sprn
For agitation and spin speeds in each cycle, see pages 6-9.
For a soak or prewash
1
For best results, use warm water
for soaking or pre-washing stained
laundrv. Hot wafer can set stains.
l Use recommended amount of
detergent or pre-soak product.
l Push Control Knob in
l Turn clockwise to point at a number
in the SOAK Cycle...use the 6-minutes
mark for a pre-wash:
l Pull Control Knob out to start washer
l When the cycle is over add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
l Set the washer and start the next
selected wash cycle
Important: See additional care information on page 7 of your
“Laundry Guide!’
10
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.