Whirlpool WTW8200Y Series Parts list manual

PRODUCT MODEL NUMBERS
The dimensions shown show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides.
■Additional clearances might be required for wall, door, oor moldings.
■Additional spacing should be considered for ease of installation and servicing.
■Additional spacing on all sides of the washer is recommended to reduce noise transfer.
■For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are acceptable.
■Companion appliance spacing should also be considered.
WTW8200Y, WTW8240Y, WTW8400Y,
WTW8440Y, WTW8600Y, WTW8800Y
Top Load Washer
Front view Side view Closet door
with vents
* Required spacing
157⁄8"*
(403 mm)
1"
(25 mm)
27 1/2"
(699 mm)
1"
(25 mm)
27"
(686 mm)
5"*
(127 mm)
14"* max.
(356 mm) 48 in.2*
(310 cm2)
24 in.2*
(155 cm2)
3"*
(76 mm)
3"*
(76 mm)
1"
(25 mm)
Installation spacing for recessed area or closet installation

Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation
our products, we reserve the right to change materials and specications without notice. Instructions packed with product. Specications subject to change without notice.
ELECTRICAL REQUIREMENTS
DRAIN SYSTEM
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is
recommended that a separate circuit serving only this appliance be provided.
The washer can be installed using the standpipe drain system (oor or wall), the laundry tub drain system, or the oor drain system.
Select the drain hose installation method you need.
W10410358A
09/2011
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gal. (64 L) per minute. Top of standpipe must
be at least 39" (990 mm) high; install no higher than 96" (2.4 m) from
bottom of washer. If you must install higher than 96" (2.4 m), you
will need a sump pump system.
Wall standpipe drain system
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at
least 39" (990 mm) above oor; install no higher than 96" (2.4 m)
from bottom of washer.
IMPORTANT: To avoid siphoning, no more than 41⁄2" (114 mm)
of drain hose should be inside standpipe or below the top of
wash tub. Secure drain hose with cable tie.
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number
285834), 2 Connector Kits (Part Number 285835), and an
Extension Drain Hose (Part Number 285863) that may be
purchased separately. To order, please see toll-free phone
numbers in your “Use and Care Guide.” Minimum siphon break:
28" (710 mm) from bottom of washer. (Additional hoses may
be needed.)
Floor standpipe drain system
39"
(990 mm)
41/2"
(114 mm) 41/2"
(114 mm)
41/2"
(114 mm)
30"
(762 mm)
39"
(990 mm)
See requirements for oor standpipe drain system.