Whirlpool LA68OOXP User manual

AUTOMATIC
WASHER
rare; Capacity
LA68OOXP
wave Ovens. Trash Compactors, Room Air Condllloners. Oehumldlfws. Automatic Washers. Clothes Dryers, Freezers, Aefrqerator-Freeze

Parts and features
LAUNDRY TEMPERATURE
SELECTOR MAGIC CLEAN e
LINT FILTER
(not sho wnl
\
ul
(not shown)
- AGITATOR
- BASKET
-TUB
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When youneed service or call with a
question, have this information ready:
Model Number
1. Complete Model and Serial Num-
bers (from plate under the lid near the
hinge].
Serial Number
2. Purchase date from sales slip.
Copy this information in these spaces. Purchase Date
Keep this book in the Laundry Informa-
tion Center with vour”Laundrv Guide,”
sales slip and warranty. Service Cornpony/
Phone Number
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
,

Your responsibilities
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l is installed by a qualified installer.
l is properly installed and
leveled on a floor that can
support the weight.’
l is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l is properly grounded.*
l is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the “Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES. 2
YOUR RESPONSIBILITIES. 3
SAFETY FIRST 3
STARTING YOUR WASHER 4
WHAT HAPPENS IN EACH
CYCLE. 6
OTHER OPERATING
INSTRUCTIONS 10
For a Rinse and Spin 10
For a Drain and Spin 10
ForaSoakorPre-Wash.... 10
Liquid Bleach Dispenser 11
MAGIC CLEAN ~jLint Filter 11
CARING FOR YOUR WASHER 12
Winterizing . 13
IF YOU NEED SERVICE OR
ASSISTANCE.. 14
I. Before Calling for
Assistance 14
2. If You Need Assistance 15
3. If You Need Service 15
4. If You Have a Problem 15
01984 Whirlpool Corporation -SAVE THESE INSTRUCTIONS - 3 I

Starting your washer
Before starting e I. Measure and add detergent.
your washer: I 2. Place sorted load in washer.
3. Star-t washer.
Select a Select WATER
1. LOAD SIZE
2. TEMPERATURES
l To change the setting on the LOAD
SIZE SELECTOR, turn the knob to RESET
l Then turn the knob to point at a
setting that describes the size of the
load you want to wash.
l Set the knob anywhere on or be-
tween HAND WASHABLE (a few small
items) and EX LARGE (a full load).
See your “Laundry Guide” for details
on load sizes.
l Select wash and rinse water tem-
peratures by pushing a button.
. This drawing shows a warm wash
(top temperature) and cold rinse
[bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Guide”.
j.,_ .. , ..~. -
; LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
! in the water. Too big a load or too
little water can cause wear or
tearing of load items. 0
DO NOT
OVERLOAD WASHER.
‘Approximate
fill with load.
-:. EX-LARGE (20.5 gals./77.6 L)’
.-, MEDIUM (13.9 gals.152.6 L)’
HAND WASHABLE (7.8 gals.129.5 L)’ /
q
4

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What happens in each cycle
Each cycle has different agitation and spin speeds designed for different
kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH
agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before agitation and timing starts, After agitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends.-
REGULAR HEAVY Cycle
A cycle for sturdily con-
strutted fabrics that are
REGULAR Cycle
A cycle for regular loads of
fabrics that are moderately
soiled.
)
)
PERMANENT PRESS Cycle
~1~~
KNITS/GENTLE Cycle
A cycle that gently washes
and spins delicate items
and washable knits.
6

NOTE: You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to help
with the rinsing.
NOTE: Always use cold rinse water for
permanent press fabrics.
DRAIN
No
u
Agltation

SOAK AND PRE-WASH Cycles
SUPER WASH Cycle
Brief periods of agitation
and soak time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
mended amount of
detergent or presoak
additive. The SOAK Cycle
should always be fol-
lowed by a Wash Cycle.
Use for washing heavily
soiled loads that require
maximum soil removal.
Double the amount of de-
tergent recommended
when using the SUPERWASH
1 Cycle.

I
+Pre-wash setting begins here, (see pagelo).
Special care is needed when soaking or pre-washing laundry.
See your “laundry Guide” for proper use of this cycle.
The washer will proceed to
the Regular/Heavy Cycle. If
you want a different cycle to
follow Super Wash, push in
the cycle control knob, turn
to the cycle and time you
want, pull knob out to start.

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.]
l Push Control Knob in.
l Turn clockwise to any*on the dial.
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
l Push Control Knob in.
l Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l Pull Control Knob out.
l The washer will drain and spin.
For agitation and spin speeds in each cycle,see pages 6-9.
For a soak or pre-wash
I , For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l Use recommended amount of
detergent or pre-soak product.
l Push Control Knob in.
l Turn clockwise to point at a number
in the Soak Cycle l use the 4-minute
mark for a pre-wash.
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“laundry Guide!’
l Set the washer and start the next
selected wash cycle.
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
10