Whispbar K774W User manual

K774W
Fitting Kit
EN Fitting Instructions for Basic Carrier
DMontageanleitung für Basisträgersystem
ES Instrucciones de montaje para el sistema
de transporte
FInstructions de montage pour Basic Carrier
NO Monteringsanvisning for takstativ
PT Instruções de Montagem para sistema de
transporte.
RU Установочные Инструкции для
Поперечных Балок
x 4 x 4 x 4 x 4
x 4 x 8 x 4 x 2
x 2
Revision No: 1A 1

Fitting Kit K774W
MAX kgs (lbs)
W/P WHD
Citroen
C4 Grand Picasso, 5dr MPV 13-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
C4 Grand Picasso, 5dr MPV 14-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
C4 Grand Picasso, 5dr MPV 14-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
2

Fitting Kit EN
K774W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type B crossbar
fitted. They also apply to type A, C and D.
●Use keys to remove covers.
3

Fitting Kit EN
K774W
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Set bars to length (revert to rear of these
instructions).
●Please check the rear of this manual for
information relating specifically to your
vehicle.
4

Fitting Kit EN
K774W
●Firmly tighten (3 Nm) adjusting screw.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Remove both pins from each leg. Use
tapered end of spanner located inside left
hand cover to assist.
5

Fitting Kit EN
K774W
●Detach foot from leg. Store loose parts in a
safe place.
●Select four feet assemblies and match the
left and right assemblies to the left and
right roof rack legs.
●Assemble foot from kit into leg by pressing
it down.
●Ensure foot interlocks with leg.
●Using short capscrew and washer, secure
assembly onto leg (use Hex Screwdriver
supplied with crossbar to assist)
6

Fitting Kit EN
K774W
●Apply protective strip as shown.
Trim if required.
●Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
●Do not over tighten.
●Repeat for all legs.
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Make sure there is no interference between
what you intend to carry with aerials,
sunroof or tailgate.
7

Fitting Kit EN
K774W
●Slide clamp through opening in leg.
●Ensure the clamp engages correctly in slot
inside of roof rail.
●Thread the coach bolt through the clamp
and the leg.
8

Fitting Kit EN
K774W
●Tighten the plastic knob.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all legs.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
9

Fitting Kit EN
K774W
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10