WHITE LINE PRO-STRIPE HD-50 2.0 User manual

If missing any parts or for any additional problems, please call White Line Equipment Company at 877.717.2892.
Whiteline Equipment Company | 1413 S. Meridian Road | Jasper, IN | P: 877.717.2892 | [email protected]
PRO-STRIPE
50
2.0
Made in the U.S.A.
Before you begin...
Please be careful when unpacking. Conrm that you have all necessary
components (be sure to open the lid and check inside the main body as
well). Inspect each component for defects or shipping damage before as-
sembling. Read instructions prior to assembly. If assembled incorrectly, this
unit can be damaged or will not function properly.
(A) (B) (C) (D)
Empty and Clean after every use. Don’t let chalk set.
Cleaning Instructions
Contents
Main Body Components (Factory Installed)
Front Wheels with D-Drive (2)
Rear Wheels - Free Spinning (2)
Main Hopper Housing
Frame Platform
Frame Platform Brackets
Upper & Lower Support Braces
Control Rod (1)
Upper Handle Assembly (1)
Lower Handle Assembly (1)
Hardware
(A) Cotter Pin (2)
(B) Nylon Locking Nut (4)
(C) ¾” Washer (8)
(D) 1¾” x ¼” Bolt (4)
Tools
(2) 7/16 Wrenches

Pro-Stripe HD-50 2.0
Whiteline Equipment Company | 1413 S. Meridian Road | Jasper, IN | P: 877.717.2892 | [email protected]
Assembly Instructions
Step 1
Attach lower handle to main body with (2) 1¾” x ¼” bolts, (4) flat washers, and (2) nylon locking nuts. Optionally, you can remove the wheel to make bolt
installation easier.
Step 2
Attach upper handle to lower handle. Next, align upper stabilizing arms (with bent end) over same holes on outside of handle. Secure with (2) 1¾” x ¼” bolts,
(4) flat washers, and (2) nylon locking nuts. Note: Bent end must be towards the main hopper housing.
Step 3
Attach the control rod first through the handle. Attach to the housing flow control assembly with a cotter pin.