Whitestone DOME SILK Operation manual
Ultra Thin Glass Installation User Guide
Please make sure to check manual and installation video before using the product. Please check the model and components before using the product.
Cautions before Dome silk installationAfter checking the Quick guide, check the User guide.<Quick guide / User guide>
Ultra Thin Glass Installation User GuideUltra Thin Glass Installation User GuideGlassJigReference
ComponentsSqueegeeAlign blockAlcohol WipesAnti-slip AadCleaning ClothDust Remover StickerRemover Pack(Remove Film+UTG Remover)
TOP
BOTTOM
Ultra Thin Glass Installation User GuideSTEP1STEP2Attach the anti-slip pad vertically to the back of the jig.Connect the Align block to top part of the JIG.InstallationUltra Thin Glass Installation User GuideAttaching the back side of the JigRemove the protection film attached to your device using the UTG Remove included in the Remove Pack.
Ultra Thin Glass Installation User GuideSTEP3InstallationSTEP4Insert the device into the JIG in correct direction. Top – SpeakerBottom – ConnectorClean the display with alcohol wipe and cleaning cloth. Then, remove any dust with dust removal sticker.
Ultra Thin Glass Installation User Guide
TOP
STEP5InstallationSTEP6Flip the glass with the protective lm removed so that the top/bottom text are visible to the front. 1) Insert the top part of the lm into the Align block.2) Insert the bottom part of the lm into the bottom part of the JIG.
②
③
①
TOP
Hold the top part of the film as shown, and bend the blue sticker as shown in [Figure 1]. Like [Figure 2] Make sure that the protective lm and glass are properly separated and slowly remove the protective lm. If it is as shown in [Figure 3], attach the protective lm as if it is in the rst state and remove it carefully so that only the protective lm can be removed.※Correct sticker removal direction※※Incorrect sticker removal direction※※In the case of the above, there is a sound of tearing the tape※[Figure 1][Figure 2][Figure3] Glass and protective lm are separated together.
TOP
BOTTOM
TOP
Glass
liner film
TOP
Glass
liner film
Ultra Thin Glass Installation User GuideSTEP7Hold the squeegee with both hands and slowly and forcefully push up with the squeegee from the bottom of the jig to the top 2/3 while maintaining squeegee in a lean angle. Make sure there is no bubble at the folding area. If bubble appears, proceed to STEP 7-1. If not, push the squeegee all the way to the end. InstallationMake sure there is no bubble at the folding area StartSlowly<Directions of Use>
Ultra Thin Glass Installation User GuideInstallationRemove the guide lm from the hole on the top of the jig. Detach the GLASS below the bubble by about 2cm and while holding the top of the lm with your hands, be careful not to slide the jig, and gently push it with a squeegee to attach it.STEP7-1 (When bubble appears during installation)Folding area (Bubble)
Ultra Thin Glass Installation User Guide
수평방향으로 밀어주세
요
x
STEP8Installation<Directions of Use><Directions of Use>
①
②
Push the squeegee in a horizontal direction.Remove the guide lm from Jig's hole while pressing the ①-top/②-bottom of the glass with a squeegee. ③Push the glass entirely to the short side of the squeeze.③
Ultra Thin Glass Installation User GuideInstallationSTEP9Bend the guide lm attached to the glass and remove it from the top.Finish by pressing the glass edge with the short part of the squeegee. Remove the device from the JIG.<Directions of Use>※Correct gudie lm removal direction※※Incorrect gudie lm removal direction※
Ultra Thin Glass Installation User GuideSTEP1STEP2Remover InstallationHold the handle of the Removal Film and peel o the yellow paper about 1/3 and attach it in alignment with the GLASS. Push the UTG REMOVER between the device and the GLASS to make a gap, and then slowly pull up the both GLASS and UTG REMOVER together to remove while holding the device immovable. Remove InstallationSTEP3After removing dome silk,if there is glass powder or dust remove it using scotch tape, etc.
Ultra Thin Glass Installation User Guide
Please check the installation Guide.Precautions after installationPrecautions when removing the tempered glass
CONTACT USHOMEPAGEGlobalA/SWHITESTONE Ltd.
Copyright ⓒ 2021 Whitestone Ltd. All rights reserved.
Table of contents
