Whitewood Industries C-271 User manual

ITEM
NO.
: C
-
271
REVISED JUL 6, 2012
Printed in Vietnam
- 1 -
Description
Item No.
: BEDFORD LADDERBACK CHAIR
: C-271
ASSEMBLY
INSTRUCTIONS

ITEM
NO.
: C
-
271
REVISED JUL 6, 2012
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Q
ty
Sketch
NO
Des
cription
Q
ty
Sketch
A Back 1 B Seat Frame 1
C Front Leg
(L-R) 2
D Front
Stretcher 1
E Side Stretcher 2 F Seat 1
HARDWARE LIST
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
: C
-
271
REVISED JUL 6, 2012
Printed in Vietnam
- 3 -
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
1
Short bolt
(M6x40mm)
3 2
Long bolt
(M6x80mm)
4
3
Medium bolt
(M6x60mm)
4 4
Screw
(M4x35mm)
10
5
Lock washer
(6.5x11mm)
11 6
Flat washer
(6.5x19mm)
11
7
Allen key
(4mm)
1
STEP 1
Attach seat frame (B) to the back (A) by using bolts (3) and (1), washers (5) and (6) tighten with allen
key (7) as shown below.
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to
make sure the chair is level and then tighten the bolts.

ITEM
NO.
: C
-
271
REVISED JUL 6, 2012
Printed in Vietnam
- 4 -
STEP 2
Attach front legs (C) to the seat frame.Use bolts (2), washers (5) and (6) and tighten with allen key (7).
Place side stretchers (E) and front stretchers (D) between front and back legs, use the screw driver to
tighten the screws (4) as shown below.
STEP 3
Attach the seat (F) to top of the seat frame (from Step 2) by using screws (4) tighten with a screw
driver.