Whitewood Industries T-7XB User manual

ITEM : T-7XB Printed in Vietnam
- 1 -
Description
Item No.
: TRANSITIONAL PED FOR BUTTERFLY TOP
: T-7XB
BEFORE ASSEMBLY
ASSEMBLY INSTRUCTIONS

ITEM : T-7XB Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take
the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please
separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call Toll Free: 1-888-944-8396.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following
parts:
NO Description Qty Sketch NO Description Qty Sketch
A Pedestal
column 1
B Leg 4
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the
following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Flat washer
(Φ8xΦ19mm)
12 2
Lock washer
(Φ8xΦ11mm)
12
3
Hexagon nut
(M7.8x13mm)
12 4
Wrench
(M13mm)
1
5
Allen key
(4mm)
1 6
Height adjustable
leveler
(6mm)
4
STEP 1
Attach legs (B) to column (A) with nuts (3), washers (2) and (1). Tighten with wrench (4) as shown below.

ITEM : T-7XB Printed in Vietnam
- 3 -
1
2
3
4
STEP 2
Use the Allen key (5) to loosen the bolts, and take off the mounting plate underneath of the table top.
STEP 3
Attach the mounting plate to top of the column (A) with washers (1), (2) and nuts (3). Tighten with the
wrench (4) as shown below.

ITEM : T-7XB Printed in Vietnam
- 4 -
1
2
3
4
STEP 4
Attach the mounting plate back to the table top as shown below with bolts and washers (from step 2).
Tighten with Allen key (5).
Assemble the height adjustable levelers (6) at bottom of legs (B).
5
6
STEP 5
Stand the table upright. Unlock the table top from both sides underneath of the top as shown below.
Pull the 2 parts of the table top apart.

ITEM : T-7XB Printed in Vietnam
- 5 -
STEP 6
Lift the butterfly leaf on, and spread it at center of open table top. Lock the table top parts at underneath as
shown below.