Wickes TALLINN VANITY UNIT User manual

INSTALLATION GUIDE
Tools required (not supplied)
Basin Fixings required (not supplied)
TALLINN VANITY UNIT
Wall fixing screws are not supplied, please use
suitable fixings dependent upon wall construction.
Before fitting the unit
When you are ready to start, make sure that you have the right tools to hand,
plenty of space and a clean dry area for product assembly.
Keep children away from the work area and remember that all small parts,
plastic bags and tools should also be kept out of reach of children.
Ensure there are no hidden service pipes and cables where you intended to drill.
We do not recommend the use of power screwdrivers for the assembly of this
product.
Take care not to overtighten any screws or any other fixings
The basin must be secured in place and its weight supported by wall fixings.
The weight of the basin should not be supported by the vanity unit alone.
Wall fixings are not supplied with this pack as they will vary according to the
type of walls you have. Ensure correct wall fixings are used for wall type.
When working near a basin or bath, insert the plug into the waste to avoid
the possibility of losing any small parts.
Warning

STEP 1
Using suitable fixings, install the
basin at a finished height of
approximately 850mm from the
floor level.
Using suitable fixings, install the
basin at a finished height of
approximately 850mm from the
floor level.
STEP 2
Using suitable wall fixings, install the unit directly below the basin.

Use the lower screw adjuster to
raise or lower the unit
Use the lower screw adjuster to
raise or lower the unit
Use the upper screw adjuster to
secure the unit close to the wall
Use the upper screw adjuster to
secure the unit close to the wall

Pay particular
attention to the
alignment of the basin
lip and the top of the
unit.
STEP 3
Complete the installation by applying a bead of sealant
between the lip of the basin and the unit and between the
basin and the wall. Allow sealant to cure before use.
We have taken great care to ensure that this product reaches you in perfect condition. However,
should any parts be damaged or missing please contact your point of purchase who will be happy to
assist. This does not affect your statutory rights.
Use a soft dry cloth to clean the surface of the unit.
Do not leave any standing water on the unit. Remove
any water immediately.
Never use any solvents, scourers, abrasives, bleach,
acids, strong detergents, aggressive chemical cleaners
or solvent-type cleaning solutions on the product.
If polish is to be used, use a wax free polish.
Aftercare
Limitations
Please keep in mind that each drawer
has a maximum weight limit of 30kg.
Do not overload the drawers or apply
excessive loading on to the unit.