Will Burt NightSearcher Pulsar NavStar Specification sheet

Pulsar NavStar - Quick setup manual
For fast and easy deployment the case can be folded back on itself.
Supplied with 10 x pulsars in case, AC charger and vehicle charger.
1
2
3
4
5
6

Product weight 5kg
Product size 370x150x335mm
NS Part No. 5838301
All NightSearcher products have a 3-year standard
warranty on all manufacturing defects and 1-year warranty
on all rechargeable batteries from the date of purchase.
How to reset pulsars:
• Removing all pulsars from the carry case
• Switching them all OFF, pushing and holding the round button
• Once they are all switched off, on ONE pulsar only push and hold the square button for approximately 30 seconds, a red and
amberLEDwillashinsidetheunit
• For each other pulsar now push and hold the square button for approximately 30 seconds (one unit at a time) the red and amber
LED’swillashforashorttimeandgooff,repeatthisfortheentireset.(theoriginalpulsarwillcontinuetoashduringtheprocess)
•Onceallunitshavebeenreprogrammed,pressthesquarebuttonontheoriginal(rstpulsar).TheredamberLEDswillnow
go off, release the button and set pulsar to one side
• Replace pulsars into carrying case, they should now operate correctly
Charging - 10-12 hours charging time:
Connect the charger lead into the socket and connect the charger into a power supply (AC or DC),
depending on the charger being used.
Note: The pulsar lights will not turn off until they are replaced back into the case.
Oneyouhavenishedusingthepulsar’sfoldthecasebackonitselfsothepulsars
are held in the case securely.
Warning: Never use the charger if the leads, contacts or casings are
damaged. Do not use any chargers other than those provided.
Charging Indicator:
Red light = charging in process | Green light = fully charged
Operating:
Square button to
change colour modes
Round button to
change light modes
• Remove pulsars from the charging case and place on the ground, an amber
lightwillappearandthepulsarwillstartashing.Laytheremainingpulsar
onthegroundandtheywilltheautomaticallysynchronisewiththeashing
mode of the previous pulsar.
• The buttons on any of the pulsar can be pressed to change the colour
modesand6ashingmodes.
•Presstheroundbuttontochangebetweenthe6ashingmodes.
• Press the square button to change between the colour modes
- blue/amber/red.
•Whenyouhavethepulsarssetuptothechosenashingandcolourmode,
place all Pulsars back into the pockets in the carry case, ensuring the
magnet is face down and the cluster of 4 LEDS is face up. The Pulsar are
held inside of the pocket by the magnet. Now they are ready to be charged.
2106822.6 Patent Pending
THE WILL-BURT COMPANY
401 Collins Blvd., Orrville, OH USA 44667
Telephone: [phone]
Email: [email protected]