Williams-Sonoma Magnetic Knife Bar User manual

P: 1 / 2
18 Inch Magnetic Knife Bar
Assembly & Mounting Instructions
Parts Included:
A. (1) Iron Plate
B. (1) Magnetic Knife Bar
C. (3) Anchor
D. (3) Metal Cylinder Gasket
E. (3) Screw
Hardware for Assembly:
A. (1) Iron Plate
B. (1) Magnetic Knife Bar
D. (3) Metal Cylinder Gasket
Hardware for Mounting:
C. (3) Anchor
E. (3)Screw
Tools Required: Pencil, Level, Philips screwdriver, Tape measure, Stud-finder
Pre-Assembly:
-Please read all instructions carefully before getting started.
-Remove all parts and hardware from carton box and lay them out on a clear workspace.
-Do not discard any contents until after assembly / installation is completed to avoid accidentally discarding small
parts or hardware.
-Do the assembly of this item on a flat, protected surface (e.g. a large table, floor).
-For safety and ease of assembly & mounting, two people are strongly recommended.
-The use of power tools to aid in assembly is not recommended.
-The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
MOUNTING INSTRUCTIONS:
1) Determine a desired location for the item. Mark three
insertion points on the wall as the diagram illustrated.
You may need to double verify that the dimensions are
correct –measure on the actual product and see if they
are match.
2) Use a stud-finder to determine if there is a wall stud
located at either insertion mark. If a mark does align, use
a screwdriver to screw (E) through the iron plate (A) and
metal cylinder gasket (D), locked into the plastic anchor
(C).
3) The concave of magnetic knife bar(B) align with iron
plate (A),then gently close to it, using the magnet
magnetic adsorption on the iron plate (A)
Note: The mounting hardware (O/ P) are meant for
drywall/stud mounting only. For other wall types,
please consult your local hardware store for
assistance in selecting the appropriate hardware.
A
BC
D
E

P: 2 / 2
Care Instruction:
Dust often with a soft, dry cloth.
Avoid using abrasives or strong-chemical cleaners as they may damage the finish of the product.
Warning:
STRONG MAGNETS. Handle with care when installing the magnetic bar.
Can be harmful to people with pacemaker or metallic implants. THIS IS NOT ATOY.
STRONG MAGNETIC BAR. Be careful when mounting the screws through the magnetic bar.
Can be harmful to people with pacemaker or metallic implants. THIS IS NOTATOY.
Thank you for your purchase!
www.williams-sonoma.com
123