Williams-Sonoma JERICO KNOB User manual

28-Feb-2020 1/2
© 2019 Williams-Sonoma, Inc. A
Williams-Sonoma Inc.
Assembly Instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
Pottery Barn – Pottery Barn Teen – Pottery Barn Kids – Williams Sonoma Home – West Elm – Rejuvenation – Mark and Graham
JERICO KNOB/PULL

28-Feb-2020 2/2
© 2019 Williams-Sonoma, Inc. A
Williams-Sonoma Inc.
Assembly Instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
Pottery Barn – Pottery Barn Teen – Pottery Barn Kids – Williams Sonoma Home – West Elm – Rejuvenation – Mark and Graham
CALIFORNIA PROPOSITION 65 WARNING: This product can expose you to chemicals including Lead which
is known to the State of California to cause cancer and birth defects or other reproductive harm. For more
information go to www.P65warnings.ca.gov.
PARTS INCLUDED
Knob: 1 pc 8-32 1" Truss head screw, 1 pc 8-32 1-1/2" Truss head screw
Pull: 2 pcs oval head slotted wood screws
2 pcs oval head 5/8" slotted machine screws
2 pcs oval head 1.25”slotted machine screws
2 pcs T-nuts
MOUNTING INSTRUCTIONS
This knob/Pull includes hardware that is designed to mount securely to drawer-fronts or cabinet doors that have a
thickness range between 1/2" and 1-1/2" inches. If you drawer- front or door is thicker or thinner than this range, please
obtain the appropriate size screw from your local hardware store.
Knob:Carefully determine a desired knob location and use a 3/16 inch diameter drill bit and an appropriate drill to
make the hole through the drawer/door front. Insert the appropriate length screw. Attach the knob onto
the protruding threads of the screw and rotate clockwise until snug. Use a screwdriver to tighten the screw
while gently holding the knob.
Pull: Carefully determine a desired pull location, Use slotted head screwdriver to install wood screw until resistance
For drawer with pre-drilled holes: Determine proper center to center hole matching your pulls, hammer 2pcs T
nuts on the interior of the drawer into existing hole，place pull over the holes on the exterior side of the drawer,
Use slotted head screwdriver to tighten appropriate length screw.
CLEANING INSTRUCTIONS
To maintain and protect the luster of all products, clean with a soft, damp cloth only.