Williams Sound Personal PA Receiver PPA R35N Assembly instructions

SAFETY INFORMATION
Hearing Safety:
This product is designed to ampli-
fy sounds to a high volume level
which could potentially cause
hearing damage if used improper-
ly. To protect your hearing and the
hearing of others:
1. Make sure the volume is turned
down before putting on the ear-
phone or headphone before
adjusting the volume to a com-
fortable level.
2. Set the volume level at the min-
imum setting that you need to
hear.
3. Do not allow children or other
unauthorized persons to have
access to this product.
Personal PA™R35 Receiver
Instructions For Use & Care
CAUTION!
BATTERY SAFETY & DISPOSAL
Do not attempt to recharge dis-
posable batteries, which may
explode, release dangerous chem-
icals, cause burns, or other seri-
ous harm to the user or product.
PACEMAKER SAFETY
1. Beforeusing this product with a
pacemaker or other medical
device, consult your physician or
the manufacturer of your pace-
maker or other medical device.
2. If you have a pacemaker or other
medical device, make sure that you
are using this product in accordance
with safety guidelines established
by your physician or the pacemaker
manufacturer.
CAUTION!
CAUTION!
FRM 452E ©2007 Williams Sound Corp.

2
RECYCLING INSTRUCTIONS
Help Williams Sound protect the environment! Please take the time to
dispose of your equipment properly.
Product Recycling:
Please do NOT dispose of your Williams Sound equipment in the house-
hold trash. Please take the equipment to a electronics recycling center;
OR, return the product to the factory for proper disposal.
Battery Recycling:
Please do NOT dispose of used batteries in the household trash. Please
take the batteries to a retail or community collection point for recycling.
4/11/07
APPROVALS
This product meets approval standards established for:
RoHS
FCC WEEE

3
OPERATING INSTRUCTIONS
1. Install two (2) AA alkaline or NiMH rechargeable batteries. If you’re
using rechargeable batteries, they must be charged before using.
2. Plug the earphone into the “EAR” jack on the top of the unit.
3. Turn the receiver on by rotating the volume control knob clockwise. The
receiver’s ON indicator should illuminate green.
4. Adjust the volume for your comfort.
5. To turn the receiver off, rotate the volume control knob counter-clockwise
until it clicks off. The receivers’ ON indicator should go dark.
Note: To maximize battery life, turn the receiver off when it’s not in use.
DISCLAIMER: FCC RULES LIMIT USE OF THIS EQUIPMENT TO AUDITORY ASSISTANCE.
EARPAD CLEANING
Do not immerse the earphone in water or other cleaning agent. Foam pads may
be removed and washed with a mild laundry soap solution, rinsed thoroughly,
and air-dried. Foam pads may also be replaced with new pads.
BATTERY INFORMATION
Alkaline batteries (BAT 001): 100 hours
Rechargeable NiMH batteries (BAT 026): 50 hours per charge
Batteries from other suppliers may provide different operating life.
NOTE: The ON indicator will illuminate RED to indicate a low battery

4
Williams Sound products are engineered,
designed and manufactured under carefully
controlled conditions to provide you with
many years of reliable service. Williams
Sound warrants the Personal PA™R35
Receiver against defects in materials and
workmanship for FIVE (5) years. During
the first five years from the purchase date,
we will promptly repair or replace the
Personal PA™R35 Receiver.
Earphones, headphones, batteries, cables,
carry cases, and all other accessory prod-
ucts carry a 90-day warranty. Chargers
carry a one year warranty.
WILLIAMS SOUND HAS NO CON-
TROL OVER THE CONDITIONS
UNDER WHICH THIS PRODUCT IS
USED. WILLIAMS SOUND, THERE-
FORE, DISCLAIMS ALL WARRANTIES
NOT SET FORTH ABOVE, BOTH
EXPRESS AND IMPLIED, WITH
RESPECT TO THE PERSONAL PA™
R35 RECEIVER, INCLUDING BUT NOT
LIMITED TO, ANY IMPLIED WAR-
RANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PUR-
POSE. WILLIAMS SOUND SHALL
NOT BE LIABLE TO ANY PERSON OR
ENTITY FOR ANY MEDICAL EXPENS-
ES OR ANY DIRECT, INCIDENTAL OR
LIMITED WARRANTY
CONSEQUENTIAL DAMAGES CAUSED
BY ANY USE, DEFECT, FAILURE OR
MALFUNCTION OF THE PRODUCT,
WHETHER A CLAIM FOR SUCH DAM-
AGES IS BASED UPON WARRANTY,
CONTRACT, TORT OR OTHERWISE.
THE SOLE REMEDY FOR ANY DEFECT,
FAILURE OR MALFUNCTION OF THE
PRODUCT IS REPLACEMENT OF THE
PRODUCT. NO PERSON HAS ANY
AUTHORITY TO BIND WILLIAMS
SOUND TO ANY REPRESENTATION OR
WARRANTY WITH RESPECT TO THE
PERSONAL PA™R35 RECEIVER. UNAU-
THORIZED REPAIRS OR MODIFICA-
TIONS WILL VOID THE WARRANTY.
The exclusions and limitations set out above
are not intended to, and should not be con-
strued so as to contravene mandatory provi-
sions of applicable law. If any part or term
of this Disclaimer of Warranty is held to be
illegal, unenforceable or in conflict with
applicable law by a court of competent juris-
diction, the validity of the remaining por-
tions of this Disclaimer of Warranty shall not
be affected, and all rights and obligations
shall be construed and enforced as if this
Limited Warranty did not contain the partic-
ular part or term held to be invalid.

5
If you experience difficulty with your system, call Toll-Free for Customer
Assistance:
1-800-843-3544 (U.S.A.) or [phone] (Outside the U.S.A.)
If it is necessary to return the system for service, your Customer Service
Representative will give you a Return Authorization Number (RA) and shipping
instructions.
Pack the system carefully and send it to:
Williams Sound Corp.
Attn: Repair Dept.
10321 West 70th Street
Eden Prairie, MN 55344

INSTALLING AND REPLACING BATTERIES
1. Open the battery compartment by lifting the tab on the back of the receiver with
a finger.
2. To remove depleted batteries, pull up on the fabric strip.
3. If Alkaline (non-rechargeable) batteries are being installed, slide the
battery selection switch above the battery compartment to the “Alkaline”
position. If installing NiMH (or rechargeable) batteries, slide the battery
selection switch to the “NiMH” position.
4. Press the batteries into place over the fabric strip. Be sure to observe proper
polarity (+/–). Damage due to improper battery installation may void the
warranty on the product. Close the lid.
5. When the sound becomes weak or distorted, replace or recharge batteries.
BATTERY CHARGING
Rechargeable batteries must be charged overnight before first time use. Drop-in
charger points are located on the bottom of the R35 unit. For charger availability,
please contact Williams Sound at [phone].
CHANNEL TUNING
First, set the transmitter to the desired channel. Remove the antenna and connect an
audio source. Move the receiver 25 feet away from the transmitter for tuning. Open
the battery compartment on the R35 by lifting the tab on the back of the receiver
with a finger. Locate the metal tuning slug above the batteries next to the “Channel
Tuning” label. Using a small screw driver or tuning wand, turn the tuning slug in a
counter-clockwise direction about two turns. Then, slowly turn the tuning slug in
the clockwise direction until the signal is heard. There may be two signal points
heard. The one which is received first is a false response. Be sure to continue tuning
slightly further to the correct point, which will be much louder. Tune back and forth
to find the center of the point of best response to the program being heard.
FRM 452E ©2007 Williams Sound Corp.