Winsome house WHIF373 User manual

Page: 1
Instruction Manual
Product Name:
White Wood Sliding Door Console Table
A: body B: leg C: shelf D: bolt E: Allen key
1PC
2PCS
1PC 12PCS 1PC
Assembly:
Step 1: remove drawers from the cabinet.
Thank you for purchasing this product. This product has been manufactured with the highest standards of
safety and quality.
Parts Included (verify that you have all parts before starting assembly):

Page: 2
Instruction Manual
Step 2: The next step is to attach legs (B) on each side. In order to do this, lay cabinet where the back side is
flat on the floor and the front of the cabinet is facing up. To avoid dents and scratches, lay cabinet on a
clean and soft (but firm) surface. Screw legs into the side of the cabinet (turn clockwise to tighten).
Tip: Do not completely tighten the sides (legs) to the cabinet until after the completion of Step 3
(installation of bottom shelf).
Important:
Tighten each screw firmly. DO NOT over tighten any of the screws as this may cause stripping or cause the wood
to crack. DO NOT sit or stand on the cabinet as this may damage the product and cause serious bodily injury.
Product Name: White Wood Sliding Door Console Table

Page: 3
Instruction Manual
Step 3: Insert shelf into position and screw into place. Make sure the finished side of the shelf is facing
the bottom of the cabinet, and not the bottom of the legs.
Once you install the shelf, make sure the sides (legs) are tightened (if you did not do this in Step 2).
Carefully flip cabinet to upright position.
Important:
Tighten each screw firmly. DO NOT over tighten any of the screws as this may cause stripping or cause the wood
to crack. DO NOT sit or stand on the cabinet as this may damage the product and cause serious bodily injury.
Product Name: White Wood Sliding Door Console Table

Page: 4
Instruction Manual
Step 4: Install drawers back into the cabinet.
Product Name: White Wood Sliding Door Console Table

Page: 5
Instruction Manual
Enjoy your cabinet!
Care and Maintenance:
Daily care: Wipe with clean and dry cloth.
It is important to dry the table to prevent any moisture from soaking into the wood, which may cause it to warp
or crack.