Wisco Industries 695D/925 Series Use and care manual

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 1 of 6
*For instruconal purposes, model 695D is shown in photos. However, instrucons for the 925 series are the same.*

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 2 of 6
Remove side panel by pushing the graphic panel in gently
to separate the latches. Then pull the panel up and out.
Remove (8) screws and remove the top.

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 3 of 6
Remove (4) Screws on top of the Air Lid Assembly Remove the Air Lid Assembly

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 4 of 6
Disconect motor wires (marked by yellow arrows below)

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 5 of 6
Remove (8) Screws from the motor’s bracket and disassemble the bracket.

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 6 of 6
Using the new motor, complete all steps in reverse order and you have successfully replaced your units blower motor. Your
unit is now ready for operaon.