Wisper cool P300 User manual

Model: P300

Contents

Item

Introduction

Features ..........................................2

Unpacking and Assembly ............2- 3

Directions for Use...........................3- 4

Cautions............................................4

Maintenance ...................................5

Troublesh_a_ ...............................6- 7

INTRODUCTION

Please read this OWNER'S MANUAL carefully. It will show you how

to assemble, maintain, and operate the cooler safely and efficiently

obtain full benefit from its many built-in features.

Safety Caution:

ALWAYSUNPLUGTHECOOLERFROMTHEELECTRICALRECEPTACLE

BEFOREATTEMPTINGTOASSEMBLE,OPEN,ORSERVICETHISCOOLER.

FORMAXIMUM SAFETYALWAYSPLUGTHIS COOLERINTOAN

ELECTRICALRECEPTACLEPROVIDEDBYA GROUNDFAULTCIRCUIT

INTERRUPTER(GFCI). ®

FEATURES

fOscillationknob

i f Fan knob

I u ...... Cool knob

Wnter level gange ......

....... Airfiller

...... Aspenpad

...... Powercord

..... Waterinletdeor

{Fig.l)

_ase .....

Pillar

Wheel

UNPACKINGAND ASSEMBLY

1) REMOVETHE COOLERAND ALL PACKING MATERIALS FROM

THE BOX(see Fig 2)

Unpack the cooler onto a carpet or similar soft surface.

=Cooler

=Pillar (2 pcs.)

.Base

°Wheel (4 pcs.)

=Owner's manual Cooler

Pillar Base

co@@

Wheel ' (Fig.Z}

i_ii" - IV,_-

2) ASSEMBLY

A) Push wheels (4) into the base. (see Fig 3)

B) Push pillars (2)into the base. (see Fig 4)

C) Sitthe cooler onto the pillars. (see Fig 5)

D) The cooler may be used without its stand by removing it from

the pillars. (see Fig6)

(Fig.3) (Fig. 4) (Fig.5) (Fig.6)

DIRECTIONSFORUSE

FILLING WITH WATER

Disconnect the power to the cooler before filling. Open the water

inlet door (see Fig 7) and pour in clean water. The water capacity is

1- 1/2 gallons (6 liters). The minimum amount of water needed for

the pump to operate is 1/2 gallon (2 liters).

The cooler is full when the water level meter indicates the highest

reading. Close the water inlet door after filling. No damage will

occur to the pump if the cooler is operated without water.

Caution:

•DONOTOVERFILLASWATERWILL

SPILLFROMTHECOOLER!

• BEFOREFILLINGUNITWITH

WATER,CHECKTHATTHELEVEL

INDICATORMOVESFREELY.

Waterievel .....

'Water inlet door

Plug into a power outlet

Caution: j

USEONLYTHERATEDVOLTAGE

(120VOLTS,60HZ)

(Fig.T}

COOLING

When this appliance is used as an air cooler it

should be filled with water and the 'COOL'knob

turned to the 'ON' position.

(see Fig 8)

OFF ON

COOL IFig.81

_;] .i

4) FAN SPEED

•Set the fan knob to the "HIGH" or "LOW" position.

• The cooler may be used as a fan only, this is

done by turning the "COOL" knob to the "OFF"

position. (see Fig 8)

5) OSCILLATION

• Set the oscillation knob to the "ON" position.

(see Fig 10)

How to get the best cooling performance:

1)Place the cooler with its back near an open

window or door so it can draw in 100% fresh

outdoor air. Open another window or dooron the

opposite side of the room for "flow through"

ventilation. This cooler will not cool properly in a

closed room.

2)We recommend that when the cooler is first used

it should be run for 10 minutes in the "COOL", "HIGH"

setting.

HIGH

OFF LOW

AIR (Fig.9)

OFF OH

OSCILLATION

(Fig.10J

CAUTIONS

Safety instructions:

As this cooler contains water, ensure it is moved

carefully and is not tilted or bumped as water may spill.

Always unplug the cooler from the electrical receptacle

before moving or servicing the cooler.

(Fig 11) (Fig.11|

Do not place anything on top of the ceole_

(Fig 12)

(Fig. 12)

(Fig. 13)

Cleaning: (Unplug the cooler from the electrical

receptacle before cleaning)

The exterior surfaces can be wiped with a damp

cloth and a little household detergent. Do not use

abrasive cleaners or solvents,

MAINTENANCE

Uoplug the cooler fromthe power supply before serviciog.

At least once a year, at the end of summer, it is advisable to

perform some simple cleaning on your cooler to maintain its

high efficiency. This involves cleaning the water systemand

filters. (Air filter and Aspen filter pad)

1) To Drain Water

Place a bucket under the cooler and drain

the water through the drain. (see Fig 14)

2) Air filter

Filter retainer on the rear side of

cooler can be easily removed by

using a flat screwdriver (or coin, etc.)

inserting and turning 1/4turn counter

clockwise to open. (see Fig 15)

Aspen Pad

You can remove the Aspen pad from

the unit after removing the filter

retainer. Youcan reuse the Aspen pad -{Fig.Is)

after washing and drying the Aspen

pad with fresh water. Replace the

Aspen pad after it becomes

excessively clogged or dirty.

Water "lauk

To disassemble and clean the water

tank, first you should unscrew the 4

plastic screws on the sides (2) and

rear (2)of the body and remove the

body from the water tank by tilting it

forward. (see Fig 17)

fFi9.14)

You can wash the inside of tile water tank

to remove the impurities in the tank.

Reassembly of the water tank and body

is the reverse order of disassembly.

Filter i

Aspen pad Aspell pad

(Fig.16)

(Fig.17)

TROUBLESHOOTINGGUIDE

CONDITION PROBABLECAUSE

1. Cooler will not operate at first. 1. Power outlet or supply faulty.

1.2 Wrongvoltage.

2.Coolerstopsoperatingafter 2.1 Motoroverheated.(safetycutout)

runningfor sometime.

3. No cooling. ,3.1 Coolingcontrolisoff.

3.2 Reservoirisempty.

3.3

3.4

3.5

Weather istoo humid.

Aspen filter pad and/or pump inlet

screen blocked or dirty,

Pump is not working properly.

3.6 Fan/pumpnotrunningfast enough

onrowspeed.

4. Coolersmellsbad. 4.1 Reservoirorfilter paddirty,

4.2 Water quality ispoor.

5. Coolermakesscrapingorrattling 5.1 Dirthasaccumulatedinsidepump.

noiseonnew seasonstart-up.

6. Water overflowsfrom resePvoir. 6.1 Toomuchwater hasaccumulated

insidepump,

6,2 Water levelindicatorstuck.

7. Coolerwillnot operateat all. 7.1 Electricalfault.

8. Damagedpowersupplycord.

REMEDY

1.1.1

1.1.2

1.1.3

1.2.1

Switch onpoweroutlet.

Checkpowersupply.

Checkpoweroutlet.

Checkthatpowersupplyisthe sareeasspecifiedonthe ratinglabel.

2.1.1 Wait 30-45 minutes for motor to cool down and it will restart automatically. If condition persists

take the cooler to aservice agent.

3,1.1 Turn "COOL" control on. (see Fig8 page 3)

3,2.1

3.3.1

3.4.1

Fillwith water again until water level meter is at the full position. Water capacity =

I 1/2 gallous (6 liters).

Turn"COOL"controloff(seeFig8 page3) andusecoolerasa fan.

Cleanparts- seemaintenancepage.

3.5.1

3.6.1

3.6.2

The pinup is NOT a separate electric pump, tt is connected to the fen motor and is driven

mechanically. Turn tile cooler off and completely drain tile reservoir

(see page 5}. Then refill with water (see page 5). Switch "FAN" to high speed (2). Turn the

"C00L" (cooling) control on (see Fig 8 page 3) and run the cooler for 10-15 minutes non-stop.

The Aspen filter pad should now be wet. If the pad is notvisibly wet and there is no cooling,

have Ihe cooler checked by a service agent.

Check that supply voltage is up to correct level.

Fan and pump wig pick-up speed slightly as the motor reaches normal operating temperature.

Allow the cooler to run for 30.60 minutes and check again. If there is no improvement, have

the cooler chocked by a service agent,

4.1.1 {)rainreservoirandfill thecoolerwithcleanwaten If it stillsmells,cleanthe tank andreplace

theAspenfilterpador proceedto4.2.1.

4.2.1 Addelittlevanillaessenceorperfumetothewater.

5.1.1 Proceedasin3.5.1.

6.1.1 Drainsomewaterout(see Fig14page6)

6.2.1 Slidetheindicatorup tothe full positionthenlet itdrop. if it failstooperate,haveit checked

bya serviceagent.

7.1,1 Electricalpartsmustonlybe repairedand replacedbyauthorizedserviceagents.

8.1.1 If thepower supplycordofthisapplianceisdamaged,it shouldbe replaced byan authorized

serviceagentasspecialpurposetoolsare required.

PORTABLE EVAPORATIVE COOLER LIMITED WARRANTY

AdobeAir. inc., warrants to its customersand/or consumerpurchasers ofthis portablecoolerthatthe coolerandthe parLsthereof, exceptthe evaporativecooler

pad media,wig be free from defectsin material and workmanshipfor a periodof one year from the date of initialpurchase.

I.What this warranty does notcover:.

A. Thiswarrant,/does not cover anyfailure, damage or defect that resultsfrom unauthorizedmodification or service; or fromthe use of products orreplacement

parts other thanthose from AdobeAir;inducing,but notlimitedto, motorsandpumps.

B.Thiswarranty doesnot cover anydamage ormalfunctionunlesscaused bya defect in materialor workmanship.Damageormalfunction whichis notcovered

by this warranty includes,but is not limitedto, water damageto the motor,abuse,misuse,alteration,improperinstallation/maintenance/operationor

transportationdamage.

C.This warranty does notcover replacement of coolerpads.Coolerpads are disposableitemsandtheir life expectancydependson local conditions.

D. Thiswarranty doesnot coverthe cost of a service call atthe siteof installationto diagnose causeof trouble,the cost of labor to installthe part, ormileage

allowance to or from the site.AdobeAir does notpaythe freighVpostage on any exchange.

E.Thiswarranty doesnot coverevaporative coolersinstalledend operated outsidethe continentalUnitedStates.

II. DO NOTUSE COOLERCLEANERS.COOLERTREATMENTS.OROTHERADDITIVESIN THIS EVAPORATIVECOOLER.THEUSE OFANY OFTHESEPRODUCTSWILL

V01D YOURWARRANTYAND MAY IMPAIR THE UFEOFYOURCOOLER..

IlL To obtain service under this warranty, contactthe Customer Service Department,AdobeAir.Inc., 500South 15thStreet, Phoenix, Arizona85034,or

phone 602/257-0060.Thiswarranty isthe onlywarranty extended byAdobeAirto suppliersand/or purchasersof thisevaporative cooler.AdobeAir disclaimsall

other warranties, express or implied, that arise bythe operation of the law. exceptthat implied warranties of merchantability or fitness for aparticular purpose

are limited to the duration of the warranty period. AdobeAirshall not be liablefor any incidentalor consequentialdamagewhichmay have resultedfrom any

alleged breach of warranty. Somestates do not allow limitations on how long animpliedwarranty lasts orthe exclusionorlimitationof incidental or

consequentialdamages,sothe limitations or exclusionsstated above maynot applyto you. Thiswarranty givesyouspecificlegal rights,and you may have

other rights which vary from stateto state. Since AdobeAir,Inc. follows a policyof continuousproduct improvement, it reservesthe right to change design

and specificationwithoutprior notice or liability.

Replacement Parts