Wiwiurka Baby Tadeuz User manual

Thank you for
purchasing a Wiwiurka
handmade toy!
Assembly time
30-40 min
Difficulty Level
Basic
ASSEMBLY INSTRUCTIONS
Baby Tadeuz
Please make sure you have the
following pieces:
IMPORTANT
Before
starting
You will need an electric or manual screwdriver
8 rods
2 sideboards
1 wide slat (table)
1 medium slat (seat)
2 narrow slats (footrest)
Stainless steel screws
Remove all wrapping material before you
start to assemble.
Sorting your pieces will make assembly easier.
Do not tighten all screws until completely
assembled.

Start by aligning the rods and slats to one sideboard. It's important to align
them properly so the screw goes in through the pre-drilled holes, otherwise
the wood may become split. Screw in all pieces -only halfway- into this
sideboard.
1
We suggest that you use a toothpick
or alike tool to properly align the slats
before you start screwing them into
the sideboard.
You may sit the pieces on the floor
with the sideboard on top, this will
make screwing a lot easier.

Once all rods and slats are screwed into the first sideboard, flip it over an
place the second sideboard on top to start aligning the pieces and screw
them only halfway, this will allow space to align each one of the pieces
properly.
Once everything has been put together, flip the Baby Tadeuz upside down
and apply downwards pressure on all pieces to make sure they're properly
aligned and sitting in place. Once you have verified that the Baby Tadeuz
is aligned and grounded, tighten all screws.
2
3

www.wiwiurka.com