Woodland Mills HM130MAX User manual

HM130MAX™PORTABLE SAWMILL
OPERATOR’S MANUAL
HM130MAX-MY2021-EN: Rev F Publication Date: 14-Jul-2021
14 Horsepower Electric Start
HM130MAX™is a trademark of Woodland Mills, Inc.

HM130MAX™Operator’s Manual
TABLE OF CONTENTS
Space
TABLE OF CONTENTS 1____________________________________________
INTRODUCTION 4__________________________________________________
INTENDED USE 4__________________________________________________
SAFETY, WARNING & INFORMATION SYMBOLS 5_______________________
SAFETY GUIDELINES 6_____________________________________________
WORK AREA 7__________________________________________________
INTERNAL COMBUSTION ENGINE SAFETY 7_________________________
PERSONAL SAFETY 8____________________________________________
TOOL USE AND CARE 9__________________________________________
EQUIPMENT OPERATION 10_______________________________________
MAINTENANCE 11_______________________________________________
TECHNICAL SPECIFICATIONS 12_____________________________________
OVERALL DIMENSIONS 13________________________________________
ASSEMBLY 14_____________________________________________________
1. TOOLS REQUIRED 14_________________________________________
2. UNPACKING 15_______________________________________________
3. TRACK 16___________________________________________________
RAILS & CENTRE BUNK 17________________________________________
MID & END BUNKS 19_____________________________________________
SQUARING THE TRACK AND SETTING THE WIDTH 20________________
LEVELLING FEET 21______________________________________________
LEVELLING THE TRACK 23________________________________________
CARRIAGE STOPS 24_____________________________________________
LOG CLAMPS 25_________________________________________________
LOG SUPPORTS 28_______________________________________________
4. SAWMILL HEAD ASSEMBLY 30__________________________________
FRONT POSTS 30_________________________________________________
CARRIAGE LEGS 32______________________________________________
HEAD LOCK-DOWN PLATES 33____________________________________
STANDING THE SAWHEAD UPRIGHT 34____________________________
HM130MAX-MY2021-EN: Rev F
Page of1112
14-Jul-2021

HM130MAX™Operator’s Manual
REAR POSTS 35__________________________________________________
CROSS BEAM 36_________________________________________________
LUBRICATION TANK 38____________________________________________
BATTERY CONNECTIONS 39_______________________________________
DASHBOARD & HOUR METER 41__________________________________
LIFT MECHANISM 43______________________________________________
LIFT CABLE ROUTING 45__________________________________________
LOG SCALE 47___________________________________________________
PUSH HANDLE 50________________________________________________
THROTTLE HANDLE AND CABLE 52________________________________
BAND WHEEL DOOR LATCHES 54__________________________________
ADJUSTABLE BLADE GUIDE HANDLE 55____________________________
LUBRICATION TUBING 56_________________________________________
TIGHTEN CARRIAGE WHEEL BOLTS 57_____________________________
5. PLACING THE HEAD ON THE TRACK 58__________________________
METHOD 1 58____________________________________________________
METHOD 2 59____________________________________________________
ROLLING THE SAWMILL HEAD ASSEMBLY 60_______________________
RAISING & LOWERING THE SAWHEAD 61___________________________
LEVELLING THE SAWMILL HEAD ASSEMBLY 62_____________________
ADJUST THE POST SLEEVE BUSHINGS 63__________________________
GREASING THREADS 64__________________________________________
ENGINE OIL 65___________________________________________________
PRE START-UP CHECKLIST 67_______________________________________
SAWMILL SET-UP PROCEDURES 68__________________________________
DIRECTION OF CUT 68___________________________________________
DRIVE BELT TENSION 69_________________________________________
BLADE TENSION 71______________________________________________
TENSIONING METHODS 72________________________________________
BELLEVILLE WASHER STACK 73___________________________________
BLADE TRACKING 74____________________________________________
TEST PROCEDURE 75_____________________________________________
HM130MAX-MY2021-EN: Rev F
Page of2112
14-Jul-2021

HM130MAX™Operator’s Manual
FOLLOWER-SIDE ADJUSTMENT 76_________________________________
DRIVE-SIDE ADJUSTMENT 77______________________________________
TRACKING RUN-IN 78_____________________________________________
BLADE GUIDE ADJUSTMENT 79____________________________________
ADJUSTABLE BLADE GUIDE CALIBRATION 81________________________
ECCENTRIC V-ROLLER ADJUSTMENT 81___________________________
BALL PLUNGER ADJUSTMENT 82__________________________________
CARRIAGE & GUIDE ARM ADJUSTMENT 83_________________________
SAWMILL MAINTENANCE 84_________________________________________
CHANGING THE BLADE 84________________________________________
REPLACING BELTS 85____________________________________________
TROUBLESHOOTING 88____________________________________________
REPLACEMENT PARTS ORDERING 90________________________________
EXPLODED ASSEMBLY VIEWS 91____________________________________
TRACK 91______________________________________________________
SAWHEAD 92___________________________________________________
BACK BEAM 93__________________________________________________
GUIDE BLOCK HOLDERS 94_______________________________________
BAND WHEEL HOUSING 95_______________________________________
BAND WHEEL HOUSING DOORS 96________________________________
BAND WHEELS AND BELT TENSIONER 97___________________________
ENGINE COMPONENTS 98________________________________________
CARRIAGE 99___________________________________________________
CARRIAGE LEG, WHEEL, AND SWEEPER 100________________________
LIFT MECHANISM 101____________________________________________
THROTTLE HANDLE 102__________________________________________
CABLES, TUBING & LABELS 103___________________________________
PARTS LIST 104___________________________________________________
NOTES110_______________________________________________________
HM130MAX-MY2021-EN: Rev F
Page of3112
14-Jul-2021