INSTALLATION,OPERATION & MAINTENANCE
INSTALLATION,OPERATION & MAINTENANCEINSTALLATION,OPERATION & MAINTENANCE
INSTALLATION,OPERATION & MAINTENANCE
Tel: 1300 79 1954 Web: www.stoddart.com.au mail: fse@stoddart.com.au
uct research and development, the information contained herein is subject to change without notice
The manufacturer cannot be held res
onsible or liable for any injuries or damages
of any kind occurred to ersons, a liances or others, due to lack of conformity
with the instructions indicated in this documentation.
The manufacturer also cannot be held res onsible or liable for abuse, misuse and
lack of conformity with the instructions indicated in this documentation in regards
to installation, un-installation, o eration, servicing or maintenance.
All a liances made by the manufacturer are delivered assembled and ready to
install. Any installation, un-installation, servicing, maintenance and access or
removal of any arts, anels or safety barriers that is not ermitted, does not
com ly in accordance to this documentation, or not erformed by a TRAINED AND
AUTHORISED SPECIALISTS will result in the IMMEDIATE LOSS OF THE
WARRANTY.
The manufacturer cannot be held res onsible or liable for any unauthorized
modifications. All modifications must be a roved by the manufacturer in writing
before initiating. All modifications or works erformed to this a liance must be
erformed at all times by a TRAINED AND AUTHORISED SPECIALISTS.
General Recommendations
ATTENTION
Carefully read this instruction booklet, as it contains important advice for safe installation, operation and
maintenance. Keep this booklet on hand in a safe place for future reference by other operators or service
technicians.
Do not store or use gasoline or other flammable vapours or liquids in the vicinity of this or any other appliance.
Qualified personnel, specifically trained in the following instructions, can perform installation and service of the
machine:
General Safety
Stoddart, one of our agents, or a similarly qualified person(s) should carry out any and all repairs, maintenance
and services. Any repair person(s) should be instructed to read the safety warnings within this manual before
commencing work on these units.
Do not remove any cover panels that may be on the appliance.
Shar Edges
Steel cutting processes such as those used in the construction of this appliance result in sharp edges. Whilst any
such edges are removed to the best of our ability it is always wise to take care when contacting any edge.
Particular care should be taken to avoid contact with any steel edge, and warnings should be given in regards to
the danger of such contact to any repair or maintenance person(s) prior to commencement of any servicing.
Power Cables
nsure that any damaged power cord is replaced before further use.
