Workrite Line of Sight LOS3-MM024-4-6 User manual

1 of 2 Line of Sight | [phone] | los.workriteergo.com
Assembled Line of Sight Chassis with Worksurface
ALine of Sight Power Bar Qty: 1 BPower Bar Bracket Qty: 2 C#10-24 ×¾" Phillips Head Machine Screw
Qty: 2
Required, Sold Separately
Parts Included
IMPORTANT NOTE: All daisy-chained Power Bar Systems
must be connected to only one 120 V, 60 HZ, 20 A power entry.
Do not exceed four Power Bars per dedicated power in. The user
is responsible for calculating and managing total power load.
Failure to follow these warnings may overload the system and
cause circuit breaker protection to shut down the power system.
Assembly Instructions: Line of Sight Power Bar
LOS3-MM024-4-6
D#10-¾" Phillips Pan Head Sheet Metal Screws
Qty: 2
✓ Verify That You Have All The Tools Needed For The Assembly
You will need the following tools:
Drill/driver or Phillips screwdriver with #2 tip
" open ended wrench
1 Remove Front, Rear Panels & Grommet Cover
1.1 If not already removed, remove the Front and
Rear Panels by turning the Panel Locks a quarter
turn towards the center of the panel (inward),
then pivot the panels forward to remove.
If you have Locking Panels, unlock using the
included key.
1.2 Remove the Side or Rear Grommet Covers to
route power in the desired direction.
2 Attach Brackets to Power Bar
Attach the two Power Bar Brackets (B) to the back of the
Power Bar (A) using the two #10-24 ×¾" Phillips Head
Machine Screws (C).
ELECTRICAL RATING:
Power Bar electrical rating: model: SA-MM024-4-6
15 A, 125 V per circuit
8 outlet, 6' cord
A
C
B
1.1
1.1
1.2
C#10-24 ×¾" Phillips Head Machine Screw
Hardware at actual size
Front
Panel
Panel
Lock
Rear
Panel

2 of 2 Line of Sight | [phone] | los.workriteergo.com
#1500386 Rev A
3 Attach Bracket Assembly to Chassis
3.1 Attach the Bracket Assembly to the mounting holes on the inside
front of the Chassis using the two #10-¾" Phillips Head Sheet
Metal Screws (D).
3.2 Route the cable through the grommet hole heading in the
desired direction.
4 Route Power From Workcenter to Workcenter
4.1 Route the Power Bar cable from
Workcenter to Workcenter through
the desired grommet holes.
Note: Side to side configurations
(shown) typically will use the
side grommets and back to back
configurations typically will use the
rear grommets.
4.2 Connect the Power Bar plug to the
next Workcenter's Power Bar end
receptacle.
4.3 Complete for all Workcenters
until circuit is completed.
5 Energize & Test Circuit(s)
Test to confirm all circuits are properly connected and energized.
D
Route cable
through
grommet hole
D#10-¾" Phillips Pan Head Sheet Metal Screws
Hardware at actual size
View from behind with Monitor
Li removed for clarity
4.1
4.1
View from other side
4.2
End
receptacle