World Video Sales MicroImage Video Systems SWP4031 User manual

Page 4
WARRANTY
MicroImage Video Systems warrants that each SWP4031 is free from
defects due to faulty materials or improper workmanship for a period of
one 1) year. MicroImage Video Systems further warrants that any part
which proves defective in materials or workmanship within one 1) year,
will be replaced or repaired at no cost to the user. Labor to replace
defective parts will be done without charge, provided the equipment is
returned to MicroImage Video Systems prepaid, insured and properly
packaged. Prior return authorization must be obtained from MicroImage
Video Systems.
NOTE
This warranty covers the MicroImage SWP4031 only.
CONDITIONS
This warranty is void if the warranted part has been altered or subjected
to abuse or misuse. Defective parts must be returned to MicroImage
Video Systems.
SOLE WARRANTY
This Warranty is in lieu of all other warranties expressed or implied
including, without limitation, any implied warranty or any implied
warranty of fitness for a particular purpose. MicroImage Video Systems
shall have the final right to determination as to the existence and cause of
any defect and its appropriate adjustment in accordance with the terms of
this warranty. In no event shall MicroImage Video Systems be liable for
any consequential or collateral damages.
RETURNS
All returns MUST have an RMA number. Please call, fax or email
for an RMA form. The RMA form will have the proper shipping
address for returns.
Phone [phone]
Fax [phone]
Email [e-mail]
RGB 1x3
PASSIVE VIDEO SWITCH
Operation Manual
Model SWP4031
MicroImage Video Systems
division of World Video Sales Co., Inc
PO Box 331
Boyertown, PA 19512
Phone [phone]
Fax [phone]
[e-mail]
www.mivs.com

Page 2
CONTENTS
SPECIFICATIONS............................................................................2
UNPACKING ....................................................................................3
CONNECTIONS...............................................................................3
Video ............................................................................................3
IN CASE OF DIFFICULTY................................................................3
WARRANTY.....................................................................................4
RETURNS........................................................................................4
Rev 0 09-30-1998, Reviewed 07-07-2015
SPECIFICATIONS
Input/Output 3 each for Red, Green, Blue & Sync
Common 1 each for Red, Green, Blue & Sync
Input level RGB) 1.0 Vpp Composite, 75 Ω typical
S) 0.2 - 5.0 Vpp 75 Ω typical
Output level Same as selected input
Connectors BNC female
Bandwidth Greater than 12Mhz
Temperature
Operating 0° - 40° C 32° - 104° F)
Storage -40° - 60° C -40° - 140° F)
Humidity
Operating 10% - 90% non-condensing)
Storage 5% - 95% non-condensing)
Size 8.6" W) x 7.2" D) x 2.4" H)
218.5 mm W) x 183 mm D) x 61 mm H)
Weight 1.5 lbs
Manufactured in USA by MicroImage Video Systems
Page 3
UNPACKING
The SWP4031 package includes the following items:
SWP4031 RGB Passive Video Switch unit
This operation manual
Please inspect all items carefully and report damaged or missing
items to your dealer or MicroImage Video Systems.
CONNECTIONS
Video
Connect the video sources i.e. video cameras) to the IN/OUT
connectors on the switch unit. Connect the COMMON signal from
the switch unit to the video display. Unused inputs may be left
unconnected.
The switch will only provide a 75 ohm termination for the selected
video signal. Non-selected signals are not terminated.
IN CASE OF DIFFICULTY
If you are experiencing problems with any MicroImage product,
you can contact MicroImage Support using the following methods:
Phone [phone]
Fax [phone]
Email [e-mail]
Web www.mivs.com