wplus EK028 User manual

1
Electric Kettle
User Manual

2
Product structure

3
Precautions
1. Before use, read this instruction to prevent abnormal consequences from wrong
operations.
2. After installation, plug the plug into the socket. After selecting the desired mode, the
kettle works.
3. Before use, please check whether the power supply is consistent with the specification of
the product. The use of power socket must have good ground protection, do not use a
power socket with high-power electrical appliances.
4. Before use, check whether the voltage required by the electric kettle matches the voltage
used by your home. If not, do not use this product to avoid accidents.
5. When using, the power plug of the kettle should be firmly connected to the required
power socket.
6. This appliance is intended to be used in household and similar applications.
7. Ensure that the kettle is disconnected from power in any of the following cases: no water
in the kettle or water below the rated minimum line; pouring water into the kettle; kettle
not in use; cleaning or moving the kettle; the kettle is at fault.
8. When you accidentally boil the water to no water, you should first unplug the power plug
and add an appropriate amount of cold water to lower the temperature of the heating
plate, and the power-off device will automatically recover. Then pour out the remaining
water in the kettle, and the kettle can be used normally.
9. Product has anti-dry protection device; it will automatically cut off the power when it is
overheated to prevent product damage. Also, boiling dry affects kettle’s service life.
Please avoid boiling to no water.
10. When using the product, do not put the power cord near the sharp object, keep it away
from heat resources to prevent damage to plastic parts and accidental ignition, and
cause fire.
11. It is a normal phenomenon that the kettle gets hot when/after using the kettle. When
pouring water, pick up the handle only to pour water, and do not use your hands to
contact the body to avoid being scalded by high temperature.
12. Ensure that the water does not exceed the rated maximum water level and below the
rated minimum level. Otherwise, the hot water will overflow or spray out or boil to dry,
and cause accident.
13. The kettle should be used in combination with the same model of power base.
Do not use other power bases that do not match the kettle or kettle from another
brand.

4
a
13. The kettle should be used in combination with the same model of power base. Do not
use other power bases that do not match the kettle or kettle from another brand.
14. The kettle is for boiling water, tea, and egg only, do not use for boiling milk, drinks,
coffee or alcohol, and other food etc.
15. Do not place the product on a tilted or unstable platform to prevent spreading out of
water, causing damage and accident.
16. This appliance is not to be used by persons (including children) with reduced physical,
sensory, or mental capabilities, or lack of experience and knowledge unless they have
been given supervision or instruction to avoid an accident.
17. Make sure children use this product under supervision and guidance. Do not let children
use it as a toy. Do not use the product in places where children can touch it.
18. When using or after using, pay attention to the surface temperature of the body. Please
do not get close to the kettle body to avoid scalding.
19. After finishing, please unplug.
20. If there are any problems when in use, please unplug from the socket first.
21. If the power cord is damaged, please stop using the product to avoid danger. It must be
replaced by the manufacturer or its maintenance department to avoid risk.
22. Do not soak the body, power plug or base into the water or other liquid to prevent
danger. Do not use inferior plug board transfer and other epitaxial power cord to avoid
the risk of fire.
23. If you do not follow the instructions to use the kettle, it may cause serious accidents
such as scalds.
Disclaimer
· The content of the information has been carefully checked. If there are any printing errors
or misunderstandings in the content, the company reserves the right of final interpretation.
· The appearance of the product is subject to the actual product in the package.
· Keep the user guide properly after reading.
· Please note that product specifications or technology upgrade are subject to change
without notice.

5
Functions
Electronic screen
奶茶鍵 (Milk Tea)
Select functions according to your tea preferences.
Press 1 time, the product will boil the water to 100 ℃at full power, the buzzer beeps for 2
seconds after finishing. Add tea leaves and tea bags and boil to 100 ℃for 1 minute and
beeps for 2 times after finishing. Then, keeping the temperature at 90 ℃for 5 minutes. The
prompt beeps for 3 seconds to indicate that the work completes.
Press 2 times, the product will boil the water to 100 ℃at full power, the buzzer beeps for 2
seconds after finishing. Add tea leaves and tea bags and boil to 100 ℃for 2 minutes and
beeps for 2 times after finishing. Then, keeping the temperature at 90 ℃for 5 minutes. The
prompt beeps for 3 seconds to indicate that the work completes.
Press 3 times, the product will boil the water to 100 ℃at full power, the buzzer beeps for 2
seconds after finishing. Add tea leaves and tea bags and boil to 100 ℃for 3 minutes and
beeps for 2 times after finishing. Then, keeping the temperature at 90 ℃for 5 minutes. The
prompt beeps for 3 seconds to indicate that the work completes.
萃取鍵 (Extraction)
Press 1 time to select the extraction time for 5 minutes, press again to select the extraction
time for 10 minutes, press the third time to select the extraction time for 15 minutes. During
the work, after the water is boiled to 100 ℃and beeps for 1 second, it turns to high power
extraction for 3/7/12 minutes. Then, it turns to low power extraction for 2/3/3 minutes. The
prompt beeps for 2 seconds to indicate that the work completes.
100
奶茶
煲水
輕煮
萃取
保溫
Show time /
temperature
Function keys

6
輕煮鍵 (Soft Boiling)
Press 1 time to boil egg for 1 minute, keep warm for 1 and a half minutes to boil for hot
spring egg. Press 2 times to boil egg for 1 minute, keep warm for 2 and a half minutes for
soft-boiled egg, press again to boil the hard-boiled egg for 8 and a half minutes. After the
room-temperature water is boiled to 100 ℃, it will beep for 1 second and switch to heat
preservation. When the operation is complete, it will beep for 2 seconds.
煲水鍵 (Boiling Water)
Press this button, the product will boil the water to 100 ℃at full power, then boil it with
100℃for 1 minute, and beep for 2 seconds to stop working. Press this button again to stop
working during process.
保溫鍵 (Keep Warm)
Four temperature choices to keep warm: 50℃/60℃/70℃/90℃，press 1 time to stop the
process.
Instructions
Standby Mode
When the power is on, all the indicators are on for 1 second, and the buzzer beeps shortly.
Electronic screen shows the current water temperature, lights of function keys turn off and
stay in standby mode.
Work And Cancel
Press desired function key one time, the buzzer beeps shortly and kettle operates. At the
same time, the LED light of that function key turns on. Press it again and cancel the work
mode. When operation, the indicator of function key always turns on.
Buzzer
•Press any function key, beep once shortly.
•Wrong operation, 2 short beeps.
•Press other non-cancel buttons under working status.
•Work completes, long beep.
Protective Function
Short circuit of the heating plate sensor or boiling dry: When it detects the temperature is
over 105℃, it stops heating and enters alarm status.

7
30 Seconds Memory
Cleaning
•Unplug and make sure the kettle has cooled down. Use wet towel to wipe the outside of
the kettle and the bottom lid. Using dry towel to wipe again.
•Do not use rough cleaning materials to avoid scratching the kettle body.
•Avoid using high acid or other corrosive cleansing agent to clean kettles’ parts.
•Do not soak the body and base into the water or other liquid. Keep the kettle surface dry.
Descaling
The kettle needs to be descaled regularly at least once a month. If the water quality is poor,
increase the frequency of descaling.
1. Using white vinegar：
• Pour an appropriate amount of white
vinegar into the electric kettle.
• Leave it unheated for one hour.
• Pour out the white vinegar, clean it
several times with clean water, repeat if
necessary.
Cleaning after soft cook
•Unplug and wait until the kettle cools down
•Use clean water and detergent to clean inside of the kettle.
•Place until dry
Attention：
• When cleaning the kettle, please use soft towel or similar texture materials to clean the kettle. Do not
use steel ball or other hard materials to clean.
• Never soak the kettle's base, power cord, or plug into water. (The electronic connectors on the bottom
of the kettle and the base should not be in contact with water.)
During operation, if the body
and base are separate, it
can resume current work if
put them back within 30
seconds.
2. Using citric acid：
• Pour an appropriate amount of water and
boil it.
• Add 25g citric acid and leave it for 15
minutes.
• Pour out the liquid and use water to clean
it several times, repeat if necessary.

8
Product Specification
Name
Electric Kettle
Model
EK028
Capacity
0.8L
Rated power
1000W
Rated frequency
220V~50Hz
Standard
GB4706.1-2005
GB4706.19-2008
Circuit Diagram
Troubleshooting
Problems
Causes
Solutions
The indicator light
does not turn on, the
machine does not run
Bad contact of plug and base
Re-plug the power plug to
ensure good contact
Base without electricity
Check the power socket to
make sure it is powered
The plug wire inside the base falls off
or bad contact
Professional serving
Improper use causes the electronic
board safety to burn out
Professional serving
Base is damaged by water in the base
Professional serving
The indicator light
turns on, but the
machine does not
run
Base is damaged or internal wire is
loose
Professional serving
Internal thermostat damaged
Professional serving
Water in the kettle is
dirty or discolored
The water used has a high mineral
content
Clean promptly
Note：It is common to have plastic smell in new electric kettle, please boil water several times
and pour out the water. If the plastic smell persists, fill in the water to the top and add 2
teaspoons of baking soda. Boil, drain, and clean the kettle.

9
Product materials
This product and food contact materials follow relevant international food safety
requirements
Part Name
Material
Standard
Heating plate
Stainless steel
06Cr19Ni10
(304)
GB 4806.9-2016
Filter
Lid
Screw
Glass
High boron glass
GB 4806.5-2016
Handle
Polypropylene
GB 4806.7-2016
Heating plate’s silicone
Polydimethylsiloxane
GB 4806.11-2016
Reminder: The food contact materials used by different models may be different,
please refer to the actual purchase of the machine.
Conditions of use: Avoid contact with strong acid substances for stainless steel parts.
For further information, please visit: www.wplus8.com
Retailer: PME International Company Limited Contact: (852)2690-8484
Address: RM 1709, 17/F., Shatin Galleria, 18-24 Shan Mei Street, Fotan, Shatin, Hong Kong
注：水有塑膠味道一般出現在沒使用過的新奶茶壺，前幾次煮的水應
當倒掉。如果狀況
持續發生 ，請將水注滿至最高水位，並加兩茶匙的食用蘇打，煮沸後
倒掉，再清洗奶茶壺。