X10 PM5900 User manual
X10 Wireless Technology, Inc. LIMITED 1-YEAR WARRANTY
X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be
free from defective material and workmanship for a period of one (1) year from the original
date of purchase at retail. X10 agrees to repair or replace, at it’s sole discretion, a defective
X10 product if returned to X10 within the warranty period and with proof of purchase.
If service is required under this warranty:
Return Merchandise Authorization (RMA) number.
2. Return the defective unit postage prepaid to X10 (see address on back).
3. Enclose a check for $4.00 to cover postage and handling.
4. Enclose a dated proof of purchase.
5. X10 is not responsible for shipping damage. Units to be returned should be packed
carefully.
Please visit www.x10.com/warranty
to complete your on-line warranty registration. Thank you.
For help or more information on setup, please visit: www.x10.com/support
Installation and operating instructions for ST539 Transmitter and
RE549 Receiver, both included in the PM5900 Set.
1. Plug the Powermid Transmitter (Model ST539) into a 120V AC outlet in
the room where you want to use your remote control (up to 20 feet away
from where you normally sit). Make sure the front of the unit (with the
Powermid name on it) is facing you.
2. PlugthePowermidReceiver(ModelRE549)intoa120VACoutletinthe
roomwhereyourTV,VCR,stereo,etc.,thatyouwanttocontrolislocated
(up to 20 feet away from what you want to control). Point the front of the
PowermidReceivertowardstheunityouwanttocontrol.Fullyextendthe
antenna.
Note: The Transmitter and Receiver can be in different rooms, up to 100 feet
away from each other.
3. Point your remote control at the Powermid Transmitter and press any
button.ThePowermidTransmitterreceivestheInfrared(IR)signalsfrom
your remote and converts them to Radio Frequency (RF) codes. It sends
these codes (even through walls and ceilings) to the Powermid Receiver
which converts the codes back to IR codes to control your TV, VCR, etc.
You can add more Transmitters to use your remotes in more than one room.
Add more Receivers to control equipment in more than one room. Add an IR
Extender,Model RX569(sold separately)if youwant toplace thePowermid
Receiver next to your TV, etc., instead of in front of it. Or if your equipment
is located inside a closed cabinet.
PM5900-10/01
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and used properly, that
is, in strict accordance with the manufacturers instructions, it may cause interference to radio and
television reception. It has been type tested and found to comply with the limits for remote control
devices in accordance with the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which
are designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by
unplugging the equipment, try to correct the interference by one or more of the following measures.
• Reorient the antenna of the radio/TV experiencing the interference.
• Relocate the equipment with respect to the radio/TV.
• Move the equipment away from the radio/TV.
• Plug the equipment into an outlet on a different electrical circuit from the radio/TV
experiencing the interference.
• If necessary, consult your local Dealer for additional suggestions.
NOTE: Modifications to this product will void the user's authority to operate this equipment.
Mini Timer MT522/MT10A
A Controller, Timer and Alarm Clock all in
one!Programs up to 4 modules to goon and
offat specific times, twice a day. Controls 8
modules instantly. Dims lights too.
Maxi Controller SC503
Letsyoucontrolupto16X10Modulesatthe
touch of a button from anywhere in the
house. Dims lights too!
Mini Controller MC460
Letsyou control up to 8X10 Modules at the
touch of a button from anywhere in the
house. Dims lights too!
2-Way Home Control Interface CM11A
SetupfromanIBMcompatiblePCtocontrol
up to 256 X10 Modules. ActiveHome
software & cable included.
Thermostat Set-Back TH2807
Automaticallysets-backyourcentralheating/
air conditioning. Mounts on the wall under
your existing thermostat and plugs into an
Appliance Module.
Telephone Responder TR16A
Letsyoucontrolupto10lightsandappliances
from any outside touch-tone phone.
WirelessRemoteControlSystemRC5000
Letsyoucontrol16X10modulesfrominside
or outside your home. Can also dim and
brighten Lamp Modules and Wall Switch
Modules. Works with the HR12A PalmPad
RemoteandX10RFWallSwitches(RW684,
RW694, RW724, SS13A, SS15A).
Lamp Module LM465
Can be Dimmed and Brightened from any
X10Controller.Respondsto“Alllightson”.
Rated for 300 W. Incandescent only.
2-Way version LM14A.
Appliance Module - AM486/AM466
Two pin polarized (AM486) or 3 pin
grounded (AM466). For controlling an air
conditioner,TV,stereo,etc.anywhereinthe
home. Rated 15A for heaters, coffee pots
etc.; 1/3 H.P. for motors; 400W for TVs;
500W for lamps. 2-Way versions available
AM14A (2 pin), AM15A (3 pin).
Wall Switch Module WS467
Forcontrollingimportantindoorandoutdoor
security lights. Replaces your existing wall
switch and installs like a regular dimmer.
Dimmed/brightened from any X10
Controller. Rated 500W incandescent only.
3 - Way Wall Switch Module WS4777
Forcontrollingalightwhichiscontrolledby
two switches. Same features as WS467.
Split Receptacle Module SR227
Replacesexistingwalloutlet.The topoutlet
functions like an Appliance Module, the
bottom one is a regular outlet. Rated 15A.
ControlsANYTHINGwhichnormallyplugs
into a regular AC outlet.
Universal Module UM506
Isolatedcontactrelayandbeeper.Canbeset
formomentaryorcontinuousoperation.Not
compatible with DS7000 and DC8700
securitysystems.
CONTENTS - MERCHANDISE RETURN POSTAGE GUARANTEED
POSTMASTER: THIS PARCEL MAY BE OPENED FOR POSTAL INSPECTION
FROM
Street Address - No P.O. Box numbers (for U.P.S.)
City State Zip
First Name Last Name
X10.com, a div. of X10 Wireless Technology, Inc.
3824 North 5th St., Suite C, North Las Vegas, NV 89032
X10.com, a division of
X10 Wireless Technology, Inc.
3824 North 5th St., Suite C,
North Las Vegas, NV 89032
This manual suits for next models
2
Other X10 Receiver manuals
