up,turnitoff using yourCR12A.Repeatthese
stepsforeachcamerayou aresetting up.Make
suretochooseadifferentUnitCode foreach
camera.
ConfigureYourCameras inXRay
Vision
Run XRayVision.Rightclick inthe
programwindowandchoose"Settings"
then "Preferences"fromthe pop-up menu.Click
onthe"Cameras"tabintheconfigurationwindow.
Click on the "Add"button tocreatean entryfor
acamera.Click intothe "CameraCode"boxand
enterthe Houseand Unitcode forthiscamera.
Makesuretoenterthe letterand numberwithout
aspacebetween them.Inthe "Comment"box
you can type adescription ornameforthis
camera.Repeatthesestepsforall the cameras
you setup earlier.
You arenowreadytocontrolyourcamerasfrom
XRayVision.Rightclick inthe XRVwindowand
choose"Camera."You will be abletoselectfrom
yourdifferentcameras,ortell XRVto
automaticallyswitchbetween all ofthem.
Formorehelp,see:
http://www.x10.com/support
YourX10 multi-camerasystemallowsyou tocontrol
X10 XCam2™camerasfromyourPCand view
eachcamerafromthe XRayVision™software.
Followtheseinstructionstosetup the necessary
hardwareand software.You shouldhavepreviously
installed XRayVision on yourPCbeforestarting
thesesteps.
SetUptheTransceiverModule
Makesureyou haveconnected the
Transceiver(modelTM751)toanearby
poweroutlet. The outletyou useshouldnotbe
too closetothe back ofyourPC,as
yourPCmaycreatesomeelectrical
noisethatcouldreducethe range
ofthe transceiver.Setthe House
Code (letterdial)on the Transceiver
tothe letteryou will useforyour
cameras.
ConnecttheFirecrackerComputer
Interface
The ComputerInterface(modelCM17A)
useswireless signalstotransmitX10 control
commandsfromthe computertothe transceiver
moduleincluded inthe kit. Connectthe Interface
directlytoyourPC'sserialport. If
thereisalreadyadeviceconnected
tothisport, unplug it, connectthe
ComputerInterface,and then plug
the otherdeviceintothe connector
on the CM17A.Important: Donot
plug yourmouseintothe CM17A!
SetUpYourCameras
Setthe Houseand Unitcode on the
addressablepowersupply(model
XM10A).All ofthe camerasyou setup will be set
tothe sameletter(House)code,and eachwill have
itsownnumber(Unit)code.Plug the powersupply
intoafree ACoutlet. Connectthe cameratothe
powersupply.The camerashouldcomeon and
you shouldbe abletogetthe pictureon the TV.
Adjustthe antenna sothatitpointsbetteratthe
antenna ofthe receiver.When the cameraisset
Setting UpanX10®Multi-CameraSystem
©Copyright2000 X10 Wireless Technology,Inc.
MODEL
NUMBER:
IN37A
SETUP
INSTRUCTIONS
