XG Cargo Platform A XG-326 User manual

USER MANUAL
Platform A XG-326
Jeep Wrangler JL & JK
PARTS LIST:
FASTENER LIST:
TOOLS NEEDED: INSTALLATION TIME & SKILL LEVEL:
SCAN FOR INSTRUCTIONAL VIDEO:
Torx Wrench for
Roof Side Mounting Bolts.
(Varies by Model)
15-20 minutes, Skill Level 01
WARNING!
Platform A is engineered to support up to 150lb of evenly distributed cargo. Operator
responsible for securing all fasteners and cargo prior to operating vehicle. Do not stack cargo
to height that obstructs rear view mirror.
Do not carry flammable liquids or solids in Platform A.
Do not use Platform A as a bed of any sort.
XG Cargo warrants all products for workmanship only and cannot assume responsibility for
products abuse or misuse by the end user.
Scan the QR code with your
smartphone and it will take you
to the link below:
https://qrgo.page.link/yYQYH
www.xgcargo.com
1- Platform A Center Tray
1- Driver’s Side Mount (DS)
1- Passenger Side Mount (PS)
1- Driver’s Side Wheel Well Loop
4-- 3/8 16 x 1”
4-- 3/8 16 Nylok Nuts
8-- 3/8 Washers
5-- 1/4-20 x 3/4”
5-- 1/4-20 Nylok Nuts
10 -- #1/4” Washers
1 -- 7/32”
Allen Wrench
1 -- 5/32”
Allen Wrench

USER MANUAL
Platform A XG-326
Jeep Wrangler JL & JK
www.xgcargo.com
Remove all components
from box and be sure
all components includ-
ing fasteners are intact.
If installing with
one person,
install box or
support in
center of cargo
area to elevate
center tray to
correct height
Technical Support No. 1-833-575-8885
STEP 02:
Remove back roof side
mounting bolts ‘A’ on driver’s
side and passenger side closest
to rear seat. Install side mounts
loosely. Side mounts are
marked DS for driver’s side and
PS for passenger side.
Do not tighten these bolts
until last. Leave loose!
STEP 01: STEP 03:
STEP 05:STEP 04:
STEP 06: STEP 07:
Tighten side mounting
plate bolts last. Be sure
tray is centered in vehicle.
DO NOT USE A LEVEL TO
CHECK TRAY LEVEL. Jeeps
are preloaded higher
on driver’s side. Tray
should align with top
of back seats.
Rear Seat
SUPPORT
Install tray to side mounts
using 4 3/8 16 bolts, wash-
ers and lock nuts on each
side.There are two heights to
choose. As you tighten bolts,
be sure the mounts are
aligned with tray.
Tighten securely.
Assemble Wheel Well
Storage Loop using two
1/4-20 x 3/4” long black
bolts, washers and nuts.
Install Wheel Well
Storage Loop on driver’s
side tray support using
3 1/4-20 x 3/4 black
bolts, washers and nuts.
Tighten securely
once installed.
A
Rear Seat
A
Side rail of
mount faces
rear of vehicle
Side rail of mount
faces rear of vehicle
Bolt head on
inside of tray