Xiaomi Aqara Cube Operating and maintenance instructions

Cube Quick Start Guide
Product Introduction
Aqara Cube is a smart wireless controller that recognizes multiple actions. Configure the
Cube via app, and you can use it to control various smart accessories through linkage
control.
*A Hub is required.
*Aqara Hub is required to enable Aqara Cube to work with HomeKit technology. See
www.aqara.com for more details.
*This product is for indoor use only.
Long Press for 5s: Reconnect
Single Press: Effective Range Test
Quick Setup
1. Please add the Hub to the app according to the Hub Quick Start Guide.
2. Please open the bottom cover with the metal strip and remove the battery insulation tab.
3. Please open the app, tap “Home” and then tap “+” in the top right corner to enter “Add
Device (Accessory)” page. Select “Cube”, and add it according to instructions.

2/5
*If the connection failed, please move the accessory closer to the Hub and try again.
Effective Range Test: Single swing the Cube or single press the reset button in the Cube. If
the Hub makes voice prompts, it indicates that the Cube can communicate effectively with
the Hub.
*Avoid metal surface to maximize signal strength.
Identify an Accessory: Open the app, go to“Device List (Accessories)”page. Single swing the
Cube or single press the reset button in the Cube. If the Hub makes voice prompts and the
Cube icon in the app blinks, it indicates that the Cube is identified.
*Only Aqara Home app and Aqara app support this function.
Specifications
Model: MFKZQ01LM
Dimensions: 45 × 45 × 45 mm (1.77 × 1.77 × 1.77 in.)
Wireless Protocol: Zigbee
Battery: CR2450
Operating Temperature: -10° – +50° C
Operating Humidity: 0 – 95% RH, no condensation
Online Customer Service: www.aqara.com/support
Email: [email protected]
Manufacturer: Lumi United Technology Co., Ltd.
Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian Ave, Taoyuan
Residential District, Nanshan District, Shenzhen, China.

3/5
FCC ID:2AKIT-MFKZQ01LM
Federal Communications Commission (FCC) compliance statement
1.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following tw
o conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may caus
e undesired operation.
2. Changes or modifications not expressly approved by the party responsible for complianc
e could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B di
gital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea
sonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio com
munications.
However, there is no guarantee that interference will not occur in a particular installation. If t
his equipment does cause harmful interference to radio or television reception, which can b
e determined by turning the equipment off and on, the user is encouraged to try to correct t
he interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.

4/5
IC:22635-MFKZQ01LM
IC NOTICE TO CANADIAN USERS
This device complies with Industry Canada license‐exempt RSS standard(s). Operation is
subject to the following two conditions: (1) This device may not cause interference, and (2)
This device must accept any interference, including interference that may cause undesired
operation of the device. This device complies with RSS‐247 of Industry Canada. Operation
is subject to the condition that this device does not cause harmful interference. This Class B
digital apparatus complies with Canadian ICES‐003 (Cet appareil numérique de la Classe
B conforme à la norme NMB‐003 du Canada).
The SAR limit of CANADA (IC) is 1.6 W/kg averaged over one gram of tissue. Device
has also been tested against this SAR limit. The highest SAR value reported under this
standard during product certification when properly worn on body is 0.084W/kg.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
La limite SAR du Canada (IC) est de 1,6 W / kg en moyenne par gramme de tissu. types a
également été testé contre ces valeurs. La valeur SAR la plus élevée déclarée en vertu de
cette norme lors de la certification du produit lorsqu'il est correctement porté sur la tête est
0.084 / kg.
Hereby, LUMI UNITED TECHNOLOGY CO., LTD declares that the Radio Equipment type is
in compliance with RED 2014/53/EU. The full text of the EU Declaration of Conformity is
available at the following internet address: www.lumiunited.com/DoC.
This product can be used across EU member states.
Complies with the European Union’s“Restriction of Hazardous Substances Directive, ” which
protects the environment by restricting specific hazardous materials and products.

5/5
Symbol on the product or on its packaging indicates that this product may not be treated as
household waste. Instead it shall be handed over to the applicable collection point for the
recycling of electrical and electronic equipment.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
RECYCLING. This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be handled pursuant to
European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact
on the environment.
Symbol for “ENVIRONMENT PROTECTION – Waste electrical products should not be
disposed of with household waste. Please recycle where facilities exist. Check with your
local Authority or retailer for recycling advice.”