YachtSafe W010 User manual

N 30 32.89’
E 114 18.04’
Version 2018 l VETEL AB [e-mail] lwww.yachtsafe.se lGothenburg l Sweden
YachtSafe Manual
Remote control
W010 Remote control

Connect the alarm accessory
to the G31/G32 system via the
app for iOS or Android:
IMAGE 1 Select Alarm accessories & Relay
IMAGE 2 Add & congure accessories
IMAGE 3 iOS:New accessory
Android: Choose alarm accessory
IMAGE 4 Choose the accessory to connect.
Enter a name for the accessory and
then press Connect and follow the
instructions.
iOS: After connection of the
accessory, go to the tab Alarm ac-
cessories & Relay, press Update in
the top right. Choose to activate/
Inactivate the alarm accessory
by the button Edit in the top left.
Choose your setttings and press
Save.
Android: After connection of the
Alarm Accessory, go to the tab
Alarm accessories & Relay, press
Update. Choose to activate/inac-
tivate the alarm accessory by the
symbol in the top right (press
Edit). Choose your settings and
press Save.
iOS instructions
Android instructions
IMAGE 1 IMAGE 2 IMAGE 3 IMAGE 4

Mounting
The main function of the remote control is to turn on and o the GPS-alarm. There
is also a SOS button that activates an alert message with position information
which is sent to the predened alarm numbers. It’s also possible to put the alarm
unit in a low power consumption mode or control power of an external device, e.g.
a heater or fridge in a boat. The communication between the remote control and
the alarm unit is bidirectional. When the remote is ashing, it means that the com-
mand is sent and the alarm unit has received the key press. One or several remote
controls can be used for the same alarm unit.
Inactivate the alarm for theft and burglary.
Activate the alarm for theft and burglary.
Send a text message with the position of the alarm unit by holding the button down for
three seconds.
This button has two dierent functions.
• By pressing the button you can turn on or o the alarm unit’s output (this can be used to
control an external device, e.g. a heater or fridge). Valid only if the alarm unit‘s output is
set as user control (o or on in App).
• To switch to the low power consumption mode hold down the button for about 10
seconds until the LED-light is ashing once. You also receive a text message with status
information to your predened alarm numbers. To switch back you just hold down the
button again for about 10 seconds until the light is ashing.
Technical specications
Measurements:
Battery lifetime:
Type of battery:
Battery capacity:
Distance range
(free sight):
Temperature range:
Sealing:
58 x 30 x 11 mm
up to 3 years
CR1632
130 mAh
approx 100 m
-30 to 70°C
IP54
Additions or adjustments to this manual can be found at
www.yachtsafe.se under the Manuals tab.