Yamaha Clavinova CLP-S308 Operating and maintenance manual

Clavinova CLP-S308/S306/370/340 Installation Procedure
Caution: Do not turn off the power or remove the USB flash memory during this operation.
1 Downloading the upgrade data
1) Download the Zip file.
2) Extract the file included in the Zip file.
3) Insert the USB flash memory into your computer.
4) Copy the file into the root directory of the USB flash memory.
2 Connecting the USB flash memory
Insert the USB flash memory containing the appropriate upgrade data
to the USB TO DEVICE terminal on the instrument.
Caution:
Make sure that the USB flash memory is connected properly to the terminal.
Do not try to force an incorrect connection; doing so may damage the terminal.
3 Installing the upgrade data
Simultaneously hold down the [PLAY/STOP] button on the panel and turn on the power.
Keep holding down the [PLAY/STOP] button until "UPd" message displays, then the LED of
"GRAND PIANO1" starts to flash.
☆ Confirm the Clavinova has completed access to the USB-Device.
4 Executing the installation
1. Press the [GRAND PIANO2] button to start the installation, then the LED of “GRAND PIANO2”
starts to flash.

2. The current progress will be displayed on the display during the installation as below.
"0 00" Checking on the installed data.
"2.CL" Deleting the ProgramFlash (Program Area #1)
"2.xx" Writing on the Program #1. "xx" indicates percentages.
"3.CL" Deleting the ProgramFlash (Program Area #2)
"3.xx" Writing on the Program #2. "xx" indicates percentages.
"4.CL" Deleting the ProgramFlash (Program Area #3)
"4.xx" Writing on the Program #3. "xx" indicates percentages.
3. When the installation is completed, “END” will appear.
4. Remove the USB-Device.
5. Turn off the power switch on the instrument.
Confirming the version number
1) Turn on the power of the instrument.
2) Use the [TEMPO/FUNCTION▼, ▲] buttons to select Function.
*For CLP-370/340 ; Select Function [F9.4].
*For CLP-S308/S306 ; Select Function [F8.4].
3) Press the [+ / YES] button to call up the version number.
4) Check that the version number is correct for the upgrade, and turn off the power of the
instrument.
Troubleshooting
☆ The power supply was cut off or the USB flash memory was removed during operation.
- Acomplete reinstall is necessary. Perform the operation again from the beginning.
☆“InS” is blinking when the power is turn on.
- The USB flash memory is not inserted.
☆ Error number (E.xx) appears and the installation cannot be executed.
Check the following:
✓Is the USB flash memory inserted correctly?
✓Is the USB connector free from dust or dirt?
✓Is the USB flash memory or the upgrade data itself damaged in some way?
Try installing it again by using another USB flash memory.