Yamaha RX-V867 Use and care manual

Firmware Update for RX-V867
Page.1 of 1
April, 2013
Subject: RX-V867 Firmware Update Version 2.43
Yamaha is pleased to offer the following firmware update to ensure the best possible
performance and latest features for your AV receiver.
This firmware
1. Lets you continue using Rhapsody/Napster* service
2. Improves network function stability *Music availability varies by regions
CHECK THE UNIT’S FIRMWARE VERSION PRIOR TO THIS UPDATE
On the remote control, press the ON SCREEN button.
Select “Information” > “System”. Your current firmware version is displayed on TV.
If your firmware version is 2.43 or higher, the AV receiver is already up-to-date.
If not, conduct firmware update by following the instruction.

FIRMWARE UPDATING PROCEDURE
IMPORTANT NOTICE
Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the
Yamaha website or through your network connection.
Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by
Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to restore proper
operation will not be covered under the Yamaha Limited Warranty.
Firmware Update Through the Internet
Requirement: Internet connection
Your receiver is connected to the Internet if you can receive Internet radio stations.
(See owner’s manual for details)
While pressing the STRAIGHT button, press the MAIN ZONE button and keep STRAIGHT button pressed until
“ ADVANCEDSETUP ” appears on the front panel display.
*“
ADVANCEDSETUP ” is displayed only for a few seconds.
Turn the PROGRAM knob until “ FIRMUPDATE ” is displayed.
Power o the receiver (Standby mode)
Enter the ADVANCED SETUP mode
Select “FIRM UPDATE” from the menu
1
2
3
ADVANCEDSETUP
FIRMUPDATE
1
RX-V867

a. Press INFO button to start the update.
(Update process may take up to 15 minutes)
*If “
UPDATEUNAVAIL ” appears, this means your receiver is already up-to-date. In this case, power off to
exit from Advanced Setup. Your AV receiver is ready for normal use.
b. When completed, “ UPDATESUCCESS ” appears on the display.
c. Turn off the power of the receiver by pressing the MAIN ZONE button.
Firmware update in progress
Start rmware update4
UPDATESUCCESS
NETWORKUPDATE VERIFYING... Sx-x:xx%
STRAIGHT buttonINFO button
MAIN ZONE button
PROGRAM knob
ON SCREEN button
a. Power on the AV receiver and press the ON SCREEN button on the remote control.
b. Select “Information” > “System”.
c. Confirm that the firmware version is updated to the latest version.
Check the updated rmware version5
Congratulations!
You have completed the firmware update. Your AV receiver is ready for normal use.
2
RX-V867