Yerasov FS-12 User manual

YERASOV MUSIC CORPORATION
www.yerasov.ru e-mail: [e-mail]
5
FOOTSWITCH FS-12
6
>
OUTPUT
Guitar pedal
User manual
FOR NOTESFOR NOTESFOR NOTES

1
44
3
21
1 -
Headphone Jack
3 - OUTPUT -
4 -
5 -
CLEAN LEAD
8 - B
9 - C
-
Input A
headphone volume control
DC adapter input
On/Off LED indicator
Cabinet type selection
toggle switch
Input
Input
On / Off switch
2 -
6 -
7 -
10
DC 9V
>
19
8
10
5
4
OUTPUT
2
36
7
PANEL DESCRIPTION
Access the battery compartment by unscrewing the
bottom cover. Always put the cover back after replacing the
battery.
BATTERY REPLACEMENT
The pedal is powered by either a 6F-22 battery or a 9V
DC adapter. We recommend using YERASOV AD9-100 or
AD9-500 adapters. For extended battery life unplug the
guitar cable when device is not being used. When used
with SCS Pedal Board power supply is not required.
APPLICATION
The SCS connector is at the bottom of the pedal, the cable
is included in the SCS Pedal Board package. Fore more
information please visit www.yerasov.ru
YERASOV FS-12 is compatible with SCS Pedal Board.
CONNECTION POLARITY OF DC ADAPTER
Power supply(battery / DC), V............…..........................9
Current Draw, mA..........................................................10
, mA.............................30
Dimensions, mm..............……...…................
Weight, kg.......................….........................................0,25
With headphones connected
112 ?62 ?50
SPECIFICATIONS
PACKAGE CONTENTS
Guitar pedal FS-12, pcs...................................................1
User Manual, pcs..............................................................1
FS-12 is a passive footswitch with built-in speaker
simulation and a headphone amp with volume control. The
signal direction can be modified (Ato B, or Ato C) with a
toggle switch. In the A-B mode the LED indicator is on, in the
A-C mode it is off.
Attention! Use 1/4" mono jack cables for either of the
channel inputs.
When used with SCS Pedal Board, FS-12 works in a true
bypass mode unless connected to the left side of the board.
Headphone amp function works best with the optimal
impedance of 32 Ohm. Speaker simulation features two
modes - a 2X12" cab and a 1x12" cab. Use the
CLEAN/LEAD switch to select between clean/distortion
signals.
OVERVIEW
SCS PEDAL BOARD
SAFETY MEASURES
?Keep away from high humidity.
After exposure to cold, keep the device at room
temperature for at least 30 minutes before switching on.
Avoid dropping, keep away from dirt and water.
?
?