Yescom 12SPB003-F-S-06 User manual

Safety Instructions
1. Before using the product, ensure that all of the parts are
connected firmly.
2. It is the responsibility of the user or the installer to make sure
that the installation of this product conforms to local
plumbing codes and regulations.
3. Keep the small parts of this product away from children to
avoid risk of choking.
4. Children should not use this product unless sufficient
supervision is provided by adults.
5. Regularly clean the hair trap as it might be congested by
hair.
6. Ensure that the bowl is hung securely on the mounting
bracket first before using.
Package Contents
Bowl x 1 Sprayer x 1
Faucet x 1 Hose x 1
Vacuum Breaker x 1 Strainer x 1
Shampoo Bowl
User Manual
Mounting kit
(for Vacuum Breaker) x 1
Drain Hose x 1
Neck Rest x 1
Mounting Bracket x 1
Hair Trap x 1
Base
(for Vacuum Breaker) x 1
Page 1
Mounting kit
(for Mounting Bracket) x 1
Converter (3/8”) x 2

Assembly Instructions
1
Loosen the two iron rings from the vacuum breaker as shown
above.
Specifications
Shampoo Bowl Size
(L x W x H )
19” x 20” x 11”
(48 x 50 x 27 cm)
2
Thread the vacuum breaker through base and secure it with the
iron rings.
3
Install the vacuum breaker onto the bowl and secure it with the
mounting kit (for vacuum breaker).
4
Thread the sprayer through the hole of the base. Connect the
other end of the sprayer to the shorter thread of the vacuum
breaker.
Page 2

5
Connect the hose to the thread of the faucet.
6
Thread the faucet through the hole of the bowl and secure it with
the iron washer which is preinstalled on the faucet. Connect the
other end of the hose to the longer thread of the vacuum breaker.
7
Loosen the plastic ring and the rubber gasket from the
strainer.
8
Install the strainer on the bottom of the bowl. Secure it with the
rubber gasket and the plastic ring taken out in step 7.
Page 3

9
Connect the plastic hose to the bottom of the strainer.
Ensure the rubber
gasket is in the hose
before installing it
10
Connect the hair trap to the plastic hose.
These two parts are
preinstalled on the hair
trap. You need to loosen
them out first.
11
Install the neck rest onto the bowl.
12
Install the mounting bracket onto your wall with the mounting kit
(for mounting kit.)
Page 4

If necessary, use the
converter
(from 1/2”to 3/8”)
14
These two hoses should be
connected to hot and cool
water supply respectively.
( ⌀:1/2”)
13
Hang the bowl onto the mounting bracket.
Ensure this nut is
fastened firmly.
15
This part should be
connected to waste
water drainage.
(⌀:1 1/2”)
Page 5