YitaHome FTPLPB-9003 User manual

3
Notice:
1. Follow the installation instructions. Please confirm all accessories are present before installation.
2. Do not fully tighten the screws at first Fully tighten screws until all pieces are correctly assembled.
3. If you encounter any problems during installation , please contact our customer service.

Any LP-cylinder unrelated to
result in property damage.personal injury.
maintenance instruction thoroughly before installation or servicing this equipment.

26
cc
hooks
Screws Screw

Keep these small items
away from pets and children to prevent choking.
Assembly

to the Side Panels.
Attach the Base Assembly

Attach the Door Handle

The cylinder base
and the heat shield
must be on the
same side
ing

Insert the Battery
(Consumers need to purchase the batteries by themself)

Put the Lava
Rocks in the
Burner.
to balance the table.
Put lava rocks in the burner

Table Lid Hooks Manual Instructions
Step 1: Place the two hooks on the side panel in the direction of the igniter,
as shown in the figure.
Step 2: Place the Table Lid Assembly in the direction indicated in the figure.
cc 2
Ensure the fire pit has cooled down before covering the fire pit with a table lid
4 lbs of lava rocks.
s.
cc cc

Ensure the appliance is cooled down_before use.
Turn the coupling nut counter-clockwise until the regulator assembly is detached
Put the protective cap on the LPG cylinder valve and store the LPG cylinder away from
direct sunlight in a well-ventilated area.

operating and maintenance instruction thoroughly before installation or servicing this

All leak tests should be performed outdoors.
DO NOT smoke during leak testing.
Leak test should be performed once a year or after LPG cylinder or any gas
system parts had been replaced.
Mix half part liquid detergent with half part water to make leak check solution.
If there is a leak, disconnect first and reconnect, then test again. If bubbles continue to
appear after several attempts, you should replace the hose or cylinder valve.
Contact a qualified service technician if the attempts of stopping the leak(s) are unsuccessful.

Press and turn control knob to the LOW " "position. Keep pressing the control knob
and press the IGNITOR button " "until the burner is lit.
Once the burner is lit, continue to hold the control knob in the LOW " " position for 20 seconds.
5.Release and turn the control knob counterclockwise to the HIGH " " or the desired flame height.
Wear heat-resistant gloves, put a lit long match or lit long butane lighter near
Press and turn control knob to the LOW" " position.
the
4. Hold the control knob in the LOW" " position for 20 seconds.
prevent clothing ignition & burns.

Thank you for your purchase. To ensure the product works well and lasts longer for your
enjoyment, we therefore provide a general list of care and maintenance tips for you.
Before servicing or cleaning, make sure the fire pit is cooled.
expose to
sheltered

the
is tighten
or Part replacement may be
required
Part replacement may be
required
thermocouple
thermocouple
Part replacement may be
required
Gas line is worn out

the
Burner ports are clogged or
Ensure the gas line is not bent
and the burner is not clogged
Carbon deposit is accumulated
thermocouple thermocouple
Incorrect alignment of orifice
and burner aligned