ysctech PowerScope M400 User manual

Tel: [phone] Fax: [phone]
www.ysctech.com [e-mail]
Powe Scope M400 Manual

PowerScope M400 Set Up
Tel: [phone] Fax: [phone]
www.ysctech.com [email protected]
Please set up the system as shown. Your system
may look different depending on your configura-
tion.
Install the power supply cable (3pin female) and
S-video cable (4 pin male) as shown.
Install the lens into the ring focus block.
Tighten the knob screw
Install the ring light guide from the bottom side.
Tighten the set screws.
Install the pole extender if provided.

PowerScope M400 Operation
Tel: [phone] Fax: [phone]
www.ysctech.com [email protected]
Lens Adapters Available X0.3 X0.4 X0.5 X0.7 Standard X1.4 X2.0
Part Number MX03 MX04 MX05 MX07 MX14 MX20
Magnification
(14" monitor and 1/2" CCD cam-
era)
10X to 60x 13X - 80X 17X - 100X 23X - 140X 33X to 200X 46X - 280X 66X - 400X
Horizontal field of view (mm) 28.3 - 4.67 21.2 - 3.5 17 - 2.8 12.1 - 2.0 8.5 to 1.4 6.1 - 1.0 4.3 - 0.7
W.D. (mm) 283 211 170 119 90 55 33
The operation for PowerScope M400 is very straightforward. Please set up the lens and camera with stand,
lighting, video and computer accessories. And connect all the cables accordingly. Your system may come
with different focus block from the image shown depending on your application.
To focus the image, simply bring the lens to the right working distance depending on your lens adapter. If
there is no lens adapter installed, then the working distance is 90mm. For parfocal setting, zoom to the high-
est, then use the focus block to bring to image to focus.
Working Distance