Zanflare F2 User manual

zanflare Instruction Manual 
F2 flashlight
Congratulaons for purchasing our zanflare flashlight. You have chosen a high quality product
designed from the latest technology. For the best use of our products, please read the instrucon
manual carefully.
Features
Specificaons
Cree XP-G2 LED with a lifespan of more than 50,000 hours
Maximum output of 200LM
Constant current circuit design, ensures maximum protecon of LED life.
Made of light weight, high strength aero grade aluminium alloy
HAIII military grade hard-anodized
IPX8 Waterproof standard
Drop test impact resistance 1.5 meters
Reverse polarity protecon guards against improper baery installaon.
With memory funcon, automacally turns on with the last mode enabled.
Powered by 2 AA baeries
1 x Flashlight
1 x Lanyard
1 x Clip
2 x O-ring
Accessories
Low Medium High Strobe
Output 15LM 50LM 200LM 200LM
Runme 32H 8H 0.63H -
With smart indicator: when the baery power is higher than 30%, the blue light will blink for 5
seconds, When the power is less than 10%, the red light will flash every 1sec.
Size Length: 155mm Body diameter: 19mm
weight 73g (without baery)

Long press the tail switch to turn the flashlight on / off.
Once turned on, gently press the tail switch to switch between the four different modes:
low - medium - high- strobe.
When the baery power is higher than 30%, a blue light will blink for 5 seconds.
When the baery is between 10% and 30%, a red light will flash every 5 seconds.
When the baery power is less than 10%, the red light will flash once every 1second and
automacally access a lower brightness mode.
Instrucons
Unscrew the tail cap and inset the two AA baeries, make sure the baeries are inserted with
the posive (+) end poinng to the head, then ghten snugly the tail cap.
Baery Specificaons
Baery replacement
Turn on/off
Gently press to cycle
through:
Low→ Mid → High → Strobe

Do not disassemble the sealed head, as this may damage the flashlight and will void the warranty.
Please use high-quality baeries, when the flashlight is not in use please remove the baeries
or you run the risk of the flashlight being damaged by baery leakage and baery explosion.
Due to the sensive touch switch, the flashlight may mistakenly lit in the bag. To avoid this this
problem, you can loosen the tail cap before storing.
Aer long-term use remember to replace the O-ring to maintain the flashlight waterproof performance.
Please clean oen the conducve contact surface of the flashlight to ensure normal operaon.
If the LED indicator is flashing irregularly or is not flashing at all, there might be two reasons:
1. The baery is low and needs to be replaced (note the posive and negave direcon when
loading the new baery).
2. PCB board conducve contact surface and cylinder body may be dirty. Please clean with alcohol
swabs.
If the problem persists, please contact the aer-sales service.
30 days free replacement
any defecve product can be replaced or repaired within the 30 days of purchase. The customer
can choose between free replacement and free repair. If the customer ask for free replacement,
he can only ask for the same version of the product bought, and if that version is not available or no
more produced, we'll replace another product of the same brand with similar or beer performances.
Use and maintenance
Warranty
2 years free maintenance
free maintenance within 2 years of purchase, if the product is found to be defecve under normal
condion of use.