Zealot S32 User manual

User Manual for Zealot S32 Portable
Water Resistant Bluetooth Speaker

Specifications
- Model: S32
- Bluetooth version: 5.0
- Frequency range: 20-20000Hz
- Battery capacity: 2000mAh/3.7V
- Max. battery life: 6h
- Charging time: around 3h
- Output power: 5W
- SNR: over 85dB
- Transmission distance: about 10m
- Dimensions: 74mm x 74mm x 123mm
- Weight: 320g
1. On/Off; Mode switch
2. Previous song; Volume down
3. Next song; Volume up
4. Charging port
5. USB port
6. MicroSD/TF card
7. Indicator light
8. AUX port

Mode switching sequence
Use the Mode Switch button to select the mode you want. The switching
sequence goes as follows:
Bluetooth -> MicroSD/TF card -> AUX input -> USB input -> Radio
Bluetooth connection
To connect the speaker with your device, long-press the Mode switch button
and you’ll hear the prompt “Bluetooth Mode”. Turn on the Bluetooth on your device
and search for “Zealot-S32”, tap on it, and pair it with the speaker
If you lose the connection, your speaker will try to reconnect to the lost
connection. If the speaker does not attempt to reconnect, push the Power button to
restart the speaker or manually reconnect via the phone’s Bluetooth menu.
Button configuration
During an incoming call:
- Single tap the Power button: answer the call
- Long press the Power button: reject the call
During a music play:
- Single tap + or - buttons: next or previous song
- Long press + or - buttons: adjusting the volume
- Single tap the Power button: Play/Pause the song
MicroSD/Aux/USB mode
Insert the MicroSD/TF card and you’ll hear the Music Mode prompt. The
speaker will automatically play music from the card.
Connect another music device via Aux mode and you’ll hear the Line in Mode
prompt which means the speaker switched to the Aux mode automatically.
Insert the USB flash drive into the speaker and you’ll hear the Music Mode
prompt. The music from the flash drive will start automatically.
Charging
When the battery is low, you’ll hear the “Low battery, please charge” prompt.
To charge the speaker, plug the USB cable into the power adapter (not included) or
the computer’s USB port. The red indicator light will light up when charging and it will
turn off when the speaker is fully charged.
Please bear in mind that the charging time may vary by different power
adapters, different USB charging ports on the computer, etc.