Zehntner ZAA 2300 User manual

Zehntner GmbH
Testing Instruments
Gewerbestrasse 4
CH-4450 Sissach
Switzerland
Tel [phone]
Fax [phone]
[e-mail]
www.zehntner.com
last update: 10.10.2007 page 1
Instruction
version 1.0 dated 10.10.2007
ZAA 2300
transport arrangements
never ship the unit with mounted weight
store this instruction together with the original packaging
the apparatus has to be transported in the original packaging
All warranty and liability claims for damages will be refused if the
instructions for the transport arrangements have not been observed.
Demounted nominal condition before and after transport:
Material for mounting / demounting:
weight
knurled
screw
knurled
screw
screws screws
side frame left
side frame
right
allen key
weight
slide

Instruction ZAA 2300 transport arrangements version 1.0
page 2 last update: 10.10.2007
Mount the left side frame on the ZAA 2300 as shown below. Usually, the screws have
to be inserted in the top cut out diameters, tighten them using the allen key.
(The bottoms cut out diameter are prepared for applications using wire or profiled
applicators at substrates with film thickness as from 5 mm.)
Afterwards put the weight into the weight slide at the left side
frame and fix it with the knurled screw.
Place the right side frame to the ZAA 2300 so that the weight will fit into the weight
slide, fix it with the knurled screw and afterwards fix the right side frame in the same
way as the left side frame.
For remounting proceed in reversed order.
left