Zektor ZEK-HDMI2-SP2 User manual

ZEK-HDMI2-SP2
QUICK SETUP GUIDE
B
A
C
INITIAL SETUP
1CONNECT INPUT DEVICE
Using the ‘HDMI Input’ port A, connect to the
source device (i.e Blu-Ray player) using a HDMI
cable
(not supplied).
2CONNECT OUTPUT DEVICES
Using the ‘HDMI Output’ ports B, connect your sink
device (i.e TV) using a HDMI cable (not supplied).
3CONNECT POWER
Use the supplied power supply, connect to the DC
5V port C. Ensure the sink devices are powered on
before powering on the splitter.
Please note: Certain sources will only read the
EDID once, so if you are not getting the correct
resolution, please try rebooting the source device.
Zektor US, Inc
12635 Danielson Court, Suites 201/202/203,
Poway, CA, 92064
[email protected] | [phone]
www.zektor.com
DC 5V INPUT
HDMI UHD 18Gbps
1-2 HDMI SPLITTER
OUTPUT 1 OUTPUT 2

www.zektor.com
1-2 HDMI SPLITTER
ZEK-HDBT2-SP2
Distribute high speed HDMI video from
1 input to 2 HDMI outputs simultaneously.
COPYRIGHT NOTICE
No part of this document may be reproduced, transmitted,
transcribed, stored in a retrieval system, or any of its part translated
into any language or computer le, in any form or by any means
(electronic, mechanical, magnetic, optical, chemical, manual,
or otherwise) without express written permission and consent from
Zektor US, Inc
© Copyright 2019 Zektor US, Inc. All Rights Reserved.
Version 1.0 - April 2019